Which of the following parameters govern the value of shear angle in continuous chip formation?

A. True feed

B. Chip thickness

C. Rake angle of the cutting tool

D. All of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Two 1 mm thick steel sheets are to be spot welded at a current of 5000 A. Assuming effective resistance…
  2. Work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm…
  3. The guideways are of
  4. Tool life is generally better when
  5. Continuous chips with built up edge are formed during machining of
  6. An important geometrical quantity in the cutting of metals which can be used as a criterion for machinability…
  7. The floating position of the holding fixture in a rotary transfer device is used to
  8. In drilling aluminium, a drill with
  9. In a shaper, the metal is removed during
  10. Glazing in grinding wheels can be decreased by
  11. In electrochemical machining, the gap between the tool and work is kept as
  12. Which of the following parameters influence the axial feed rate in centerless grinding?
  13. The object of caulking in a riveted joint is to make the joint
  14. In reaming process
  15. Side rake angle of a single point cutting tool is the angle
  16. Which of the following process is used for preparing parts having large curved surfaces and thin sections?
  17. For turning internal tapers, the suitable method is
  18. The correct sequence of tool materials in increasing order of their ability to retain their hot hardness…
  19. Glazing in grinding wheels takes place when the
  20. In down milling, the thickness of chip is
  21. Crater wear is predominant in
  22. The advantage of a broaching operation is that
  23. The lead screw of a lathe has _________ threads.
  24. Chemical milling operation is performed
  25. The size of abrasive grain required in a grinding wheel depends upon the
  26. An operation of embossing a diamond shaped pattern on the surface of a workpiece, is known as
  27. Which of the following statement is correct as regard to up milling?
  28. The abrasive slurry used in ultrasonic machining contains fine particles of
  29. If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten…
  30. Which of the following operations can be performed with milling cutters?