Home

Which of the following statement is correct for gears?

A. The pitch circle diameter is equal to the product of module and number of teeth

B. The addendum is less than dedendum

C. The pitch circle is always greater than the base circle

D. All of the above

Related Questions

  1. Two closely coiled helical springs with stiffness k₁ and k₂ respectively are connected…
  2. According to Indian standards, total numbers of tolerance grades are
  3. If a material fails below its yield point, failure would be due to
  4. The maximum bending stress in a curved beam having symmetrical section always occur at the
  5. The efficiency of a square threaded screw is maximum if the helix angle is equal to (Where φ =…
  6. When bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and…
  7. The relation between the pitch of the chain (p) and pitch circle diameter of the sprocket (D) is given…
  8. An elastic bar is fixed at the upper end and loaded at the lower end by a falling weight. The shock…
  9. The process which improves the machinability of steels, but lowers the hardness and tensile strength…
  10. For circumferential joint in boilers, the type of joint used is
  11. According to Unwin's formula, the relation between the diameter of rivet hole (d) and the thickness…
  12. The tension on the slack side of the belt is __________ the tension on the tight side of the belt.
  13. The cracks in helical springs used in railway carriages usually start on the inner side of the coil…
  14. The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure…
  15. The velocity factor for ordinary cut gears operating at velocities upto 12.5 m/s is equal to
  16. A metal pipe of 1 m diameter contains a fluid having a pressure of 1 N/mm². If the permissible…
  17. The shock absorbing capacity of a bolt can be increased by
  18. According to maximum shear stress theory, the maximum shear stress in the shaft is
  19. Which of the following statement is correct?
  20. In hydrostatic bearings
  21. In designing thick cylinders, the equation used is
  22. The groove angle of pulleys for V-belt is
  23. Machine screws are
  24. According to Indian standard specifications, 100 H6/g5 means that
  25. Applications in which stresses are encountered in one direction only uses following type of threads
  26. In order to determine the stresses in a thin cylinder due to an internal pressure, it is assumed that
  27. In designing a flange coupling, the pitch circle diameter of bolts is taken as (where d = Diameter of…
  28. In a band and block brake, the ratio of tensions on the tight and slack sides of band is given by (where…
  29. The speed of the sprocket reduces as the chain pitch __________ for a given number of teeth.
  30. When the speed of belt increases,

Please do not use chat terms. Example: avoid using "grt" instead of "great".