Home
Current Affairs January 2024

What is the correct answer?

4

Which of the following WAN categories does ISDN fall under?

A. Dedicated circuit connection

B. Circuit-switched connection

C. Packet-switched connection

Correct Answer :

B. Circuit-switched connection


Related Questions

What is the correct answer?

4

Which Frame Relay command is used to manually resolve addresses?

A. frame-relay interface-dlci

B. frame-relay map

C. frame-relay resolve

D. frame-relay lmi-type

What is the correct answer?

4

Which of the following is not an advantage of DHCP?

A. It allows for the use of private addressing.

B. It reduces the amount of configuration on devices.

C. It reduces likelihood of configuration errors.

D. It gives you more control by centralizing IP addressing information.

What is the correct answer?

4

The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a router).

A. Demarcation point

B. Carrier switch

C. Local loop

D. CPE

What is the correct answer?

4

What must you do to enable IP routing on your router? (Choose all of the correct answers.)

A. Enable the routing protocol.

B. Set clocking on all serial interfaces.

C. Assign IP addresses to your router's interfaces.

D. Assign the bandwidth parameter to your serial interfaces

What is the correct answer?

4

Which type of traffic is sent to a group of devices?

A. Multicast

B. Unicast

C. Broadcast

D. Groupcast

What is the correct answer?

4

When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.

A. CIR

B. DE

C. BECN

D. FECN

What is the correct answer?

4

_________ describe(s) users working from home.

A. SOHO

B. Branch office

C. Regional office

D. Corporate office

What is the correct answer?

4

Which prompt indicates that you are at User EXEC mode?

A. >

B. #

C. %

D. @

What is the correct answer?

4

When connecting a switch to a router, use a ___________ cable.

A. Crossover

B. Straight-through

C. Rollover

What is the correct answer?

4

There are _________ actions a router can take when there is a match on an ACL statement

A. 1

B. 2

C. 3

D. 4

What is the correct answer?

4

What would you use to prevent a packet from traveling around a routing loop forever?

A. Split horizon

B. Poison reverse

C. Hold-down timer

D. TTL

What is the correct answer?

4

Which 2950 command assigns a VLAN to an interface?

A. vlan-membership static

B. vlan

C. switchport access vlan

D. switchport mode access

What is the correct answer?

4

You are given a Class C network, 192.168.1.0/24. You need one network with 120 hosts
and two networks with 60 hosts. How many subnet masks do you need?

A. 1

B. 2

C. 3

D. 4

What is the correct answer?

4

Which router command specifies the ISDN switch the router is connected to?

A. isdn switch-type

B. isdn connection-type

C. isdn spid1

D. interface serial0:15

What is the correct answer?

4

172.16.240.256 is a class __________ address.

A. A

B. B

C. C

D. None of the above

What is the correct answer?

4

The _________ reference point defines the connection between the NT2 and the NT1.

A. P

B. Q

C. R

D. T

What is the correct answer?

4

Ethernet ___________ has/have both a physical and logical bus topology.

A. 10BaseT

B. 10Base2 and 10Base5

C. 10BaseT and 10Base2

D. 10BaseT, 10Base2, and 10Base5

What is the correct answer?

4

Which command assigns a default gateway to the 2950 switch?

A. (config)# default-gateway

B. (config-if)# default-gateway

C. (config-if)# ip default-gateway

D. (config)# ip default-gateway

What is the correct answer?

4

Which of the following is a valid subnet mask value?

A. 255.0.255.255

B. 0.0.0.255

C. 255.255.254.0

D. 255.255.255.256

What is the correct answer?

4

Choose the following that a standard IP ACL can match on.

A. Destination address

B. IP protocol

C. IP protocol information

D. None of the above

What is the correct answer?

4

When configuring your terminal emulation software for a console connection, set the flow control to __________.

A. Hardware

B. Software

C. None

What is the correct answer?

4

When you have configured PPP on an interface and use the show interfaces command, what state indicates the successful negotiation of a network layer protocol?

A. ACK

B. CHALLENGE

C. CLOSED

D. OPEN

What is the correct answer?

4

_________ has a physical star topology but a logical ring topology.

A. FDDI

B. Token Ring

C. Ethernet

D. FDDI and Token Ring

What is the correct answer?

4

Which of the following is true concerning full-duplexing?

A. It can either send or receive frames, but not both simultaneously.

B. It can be used with hubs.

C. It can be used with 10Base5 cabling.

D. It uses point-to-point connections.

What is the correct answer?

4

A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.

A. WAN

B. LAN

C. MAN

D. LAN and MAN

What is the correct answer?

4

The _______ program goes out and finds the IOS and loads it.

A. ROMMON

B. Bootstrap

C. Mini-IOS

D. Loader

What is the correct answer?

4

The root switch is the one elected with the __________ __________.

A. Lowest MAC address

B. Highest MAC address

C. Lowest switch ID

D. Highest switch ID

What is the correct answer?

4

Which of the following is false concerning CHAP?

A. It sends an encrypted password.

B. It sends a challenge.

C. It is more secure than PAP.

D. It uses a three-way handshake.

What is the correct answer?

4

IOS images can be loaded from all the following except:

A. ROM

B. Flash

C. NVRAM

D. TFTP

What is the correct answer?

4

A _________ connects two or more LANs in the same geographic area.

A. LAN

B. WAN

C. MAN

D. SAN