Which router-on-a-stick command defines the VLAN for the interface?
vlan
encapsulation
trunk
frame-type
Correct Answer :
B. encapsulation
Related Questions
Annex A is which LMI standard?
Cisco
ITU-T Q.933
ANSI
With a crossover cable, which pins are crossed over?
1 and 2, 3 and 6
1 and 3, 2 and 6
1 and 4, 2 and 6
1 and 3, 4 and 6
Which command defines interesting traffic?
dialer-group
dialer-list
dialer map
dialer remote-name
Which of the following is not an advantage of DHCP?
It allows for the use of private addressing.
It reduces the amount of configuration on devices.
It reduces likelihood of configuration errors.
It gives you more control by centralizing IP addressing information.
________ topologies in NBMA environments do not have problems with split horizon.
Partially meshed
Fully meshed
Hub and spoke
Star
___________ defines LAPD, which is responsible for the data-link layer connection between the router and the ISDN switch.
Q.931
Q.921
I.921
I.931
A _________ is a network that provides a secure connection from a company to other business partners.
Intranet
Extranet
Internet
Extended traceroute works from which mode?
User EXEC
Privilege EXEC
Configuration
User and Privilege EXEC
Which type of routing protocol uses the Shortest Path First algorithm?
Distance vector
Link state
Hybrid
Which type of traffic is sent to a group of devices?
Multicast
Unicast
Broadcast
Groupcast
When configuring a router-on-a-stick, the configuration is done on __________.
Physical interfaces
Major subinterfaces
Subinterfaces
Which of the following are classless protocols?
IGRP
EIGRP
IGRP and EIGRP
Neither IGRP or EIGRP
_________ describe(s) users working from home.
SOHO
Branch office
Regional office
Corporate office
When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
pat
overload
load
port
A 1924 has _________ Ethernet interfaces.
24
26
27
28
The slot number of a 1900's Fast Ethernet uplink ports is ________.
0
1
2
No slot number is used
OSPF uses __________ as a metric.
Bandwidth
Delay
Cost
Hop count
Which of the following is true concerning 802.1Q?
It supports hub connections.
It is supported on both the 1900 and 2950 switches.
The native VLAN is tagged.
The original Ethernet frame is not modified.
Enter the wildcard mask value to match on every bit position in an address: _________.
255.0.0.0
0.0.0.0
255.255.255.255
255.255.0.0
You are given a Class C network, 192.168.1.0/24. You need one network with 120 hosts
and two networks with 60 hosts. How many subnet masks do you need?
1
2
3
4
Which control sequence moves the cursor to the end of the line?
CTRL-A
ctrl-p
ctrl-e
ctrl-z
When connecting a router to a PC, use a __________ cable.
Crossover
Straight-through
Rollover
What would you enter to see the last few commands you entered?
show version
show commands
show previous
show history
With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.
Store-and-forward
Cut-through
Fragment-free
Runtless
You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?
30
62
126
254
172.16.240.256 is a class __________ address.
A
B
C
None of the above
When examining the IP routing table, an EIGRP route will be shown as what letter?
I
E
O
D
Private addressing is defined in RFC ______.
1920
1934
1818
1918
RIP supports load balancing for up to __________ ___________ paths.
Six, unequal-cost
Four, unequal-cost
Four, equal-cost
Six, equal-cost
You have a total of five routers. ________ circuits are required to fully mesh the network, where every router needs ___________ interfaces.
5, 5
8, 4
10, 5
10, 4