What is the correct answer?


While the thermosetting polymers are amorphous in nature, the thermoplastic polymers are either amorphous or crystalline. The crystalline polymers are characterised by the

A. Low impact strength

B. High flexibility

C. Better finish and surface appearance

D. High plastic deformation

Correct Answer :

A. Low impact strength

Related Questions

Force between the molecules of the same substance is called __________… Bad odour in sanitary latrines is reduced by periodically sprinkling For a small scale toy factory, the fixed cost per month is Rs. 5000/-.… Reduction in the grain size reduces the __________ of the material. Suitability of steel for its use in cable is judged by its strength in Pick out the wrong statement about coating/electroplating of metals. The concentration of (H+) ions is 4 x 10-5 in a solution. Then pH of the… Chlorine acts as a bleaching agent only in the presence of Most of the phosphorous present in the blast furnace burden enters into When the wavelength of incident X-rays increases, the angle of diffraction Brittleness induced due to the presence of sulphur in steel can be reduced… One face of a furnace wall is at 1030°C and the other face is exposed… The thickness of oxide film is y at time t. If are the temperature dependent… Spheroidising of a material is a/an __________ process. The starting of a car takes time in winter, because the Eutectoid composition of carbon steel at room temperature is Ultimate strength in tension as compared to that in shear for steel is __________ property of a material is determined by the Herbert Pendulum… According to maximum shear stress failure criterion, yielding in material… The expected efficiency of a single riveted lap joint is of the order… For a spontaneous natural process at constant temperature and pressure,… A form of stress corrosion failure termed as 'season cracking' is generally… In an amorphous material, atoms defy any definite atomic structure and… Load cells used for the measurement of weight has Specific __________ is a dimensionless quantity. Boiling point of water gets lowered at high altitudes (e.g., hills), because Identify the correct statement with reference to the extractive metallurgy… What is the value of included angle of a triangular notch for maximum… __________ metal is used as a bearing liner material. Softening of hardened steel is done by its