Home

With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.

A. 2

B. 3

C. 4

D. 5

Related Questions

  1. Which of the following is a disadvantage of SANs?
  2. Which command is used to define the local addresses that are statically translated to global addresses?
  3. _________ is/are a routed protocol.
  4. ___________ only translates one (and only one) IP address to another.
  5. _________ negotiates the data link and network layer protocols that will traverse a PPP connection.
  6. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  7. You are given a Class B network with a subnet mask of 255.255.255.192. How many hostaddresses are there…
  8. Which of the following is not an advantage of route summarization?
  9. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  10. Which router command performs an overwrite process? (Choose all correct answers.)
  11. A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain…
  12. A 1924 has _________ Ethernet interfaces.
  13. Which router-on-a-stick command defines the VLAN for the interface?
  14. A routing protocol will use a _________ to determine which path is the best path.
  15. A ___________ is similar to a telephone circuit-switched connection.
  16. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  17. Extended traceroute works from which mode?
  18. The OSPF process ID is __________.
  19. A routing protocol that supports route summarization must perform all except which of the following?
  20. Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing…
  21. Annex A is which LMI standard?
  22. When using the show interfaces command, which Frame Relay information can you not see?
  23. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  24. Which controller command specifies how ones and zeros are represented on a digital circuit?
  25. 191.75.39.24 is a Class __________ address.
  26. A ________ topology describes how devices communicate with each other.
  27. You are given a class C network, 192.168.1.0/24. You need one network with 120 hosts and three networks…
  28. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  29. You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
  30. RIP supports load balancing for up to __________ ___________ paths.

Please do not use chat terms. Example: avoid using "grt" instead of "great".