Home

With increase in annealing temperature, the following defect density decreases.

A. Vacancy

B. Dislocation

C. Grain boundary

D. All of these

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. An alloy of Fe - 0.4 % C is
  2. Resilience of a bolt can be increased by increasing its
  3. What is the range of tempering temperature (°C) for most of the materials?
  4. Ammonia gas can be dried by
  5. The only suitable method for hardening the low carbon steel is case hardening. Which of the following…
  6. Superheating of steam is done at constant
  7. Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at…
  8. The behaviour of a metal specimen, which when plastically strained in tension reduces its yield stress…
  9. Regeneration of molecular sieve requires it to be heated to a temperature of about __________ °C.
  10. With increase in annealing temperature, the following defect density decreases.
  11. Which of the following is an example of cathodic protection of metals against corrosion?
  12. Window panes of aeroplanes are normally made of
  13. Hot & cold working of material causes its __________ deformation.
  14. Which of the following metals is not subjected to electrolytic refining/purification?
  15. The temperature at which ferromagnetic material can no longer be magnetised by the outside forces, is…
  16. A solution which resists change in its pH value on addition of acid/alkali is called the __________…
  17. __________ test is the appropriate test to determine whether a material is ductile or brittle.
  18. Wave length of X-rays is about 1 angstrom; however it cannot pass through a sheet of
  19. The activity co-efficient of the solute in a dilute solution
  20. The boiling & freezing points on a newly defined temperature scale in degree 'D' are 400°D & 100°D…
  21. Cold cracking in the heat affected zone of a high strength steel weld can take place because of the
  22. Function of fusible plug in a boiler is to
  23. Which of the following alloying elements is present in maximum percentage in high speed steel?
  24. The most abundant metal present in the earth's crust is;
  25. For a spontaneous natural process at constant temperature and pressure, the free energy of the system…
  26. Atomic __________ of an element is a whole number.
  27. In case of water (Prandtl number ≈ 6) flowing over a flat plate heated over the entire length,…
  28. Angular displacement can be measured suitably by a
  29. The 'transition temperature' for ductile to brittle behaviour of steel increases with increase in the…
  30. Nuclear fission of one atom of uranium-235 produces the energy equivalent to about __________ MeV.