Related Questions
What is the correct answer?
4
A __________ route is the best path to reach a destination within the topology table.
What is the correct answer?
4
Which types of memory do not maintain their contents during a power-off state?
What is the correct answer?
4
___________ has both physical and logical ring topologies.
What is the correct answer?
4
Which controller command specifies how ones and zeros are represented on a digital circuit?
What is the correct answer?
4
Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________ seconds.
What is the correct answer?
4
_________ allows you to create this summarization: 10.0.0.0/7.
What is the correct answer?
4
Which of the following is not an advantage of route summarization?
A. It requires less memory and processing.
B. It supports smaller routing update sizes.
C. It contains network problems.
D. It supports discontiguous subnets.
What is the correct answer?
4
Which router command would you use to view the configuration register value?
What is the correct answer?
4
When using debug with PAP, which of the following message types might you see?
What is the correct answer?
4
Which 2950 command assigns a VLAN to an interface?
A. vlan-membership static
C. switchport access vlan
D. switchport mode access
What is the correct answer?
4
_________ describe(s) users that can connect to a network from any location.
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
Which of the following is true concerning RIPv2?
A. It uses triggered updates.
D. It doesn't support route summarization
What is the correct answer?
4
You are given the following addressing information: 10.0.8.0/22. What type of address is this?
What is the correct answer?
4
Frames sent above the __________ limit will have their _________ bit set.
What is the correct answer?
4
Which command defines interesting traffic?
What is the correct answer?
4
Which of the following are classless protocols?
What is the correct answer?
4
With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
What is the correct answer?
4
Annex A is which LMI standard?
What is the correct answer?
4
When examining the IP routing table, an EIGRP route will be shown as what letter?
What is the correct answer?
4
__________ allows you to distribute connection requests destined to a single IP address to multiple machines.
What is the correct answer?
4
A 1924 has _________ Ethernet interfaces.
What is the correct answer?
4
Which command takes you from Privilege EXEC mode to User EXEC mode?
What is the correct answer?
4
When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
What is the correct answer?
4
RIP supports load balancing for up to __________ ___________ paths.
What is the correct answer?
4
Which router-on-a-stick command defines the VLAN for the interface?
What is the correct answer?
4
Which of the following is true concerning ACLs?
A. Order of the statements is automatic.
B. All statements are processed.
C. If no match is found, the packet is permitted.
D. You can delete a specific statement in a named list.
What is the correct answer?
4
_________ has a physical star topology but a logical ring topology.
What is the correct answer?
4
Which of the following is a disadvantage of SANs?
What is the correct answer?
4
What subnet mask would you use to set up a default route?
C. Depends on the type of network number