You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?

A. 00011011.10100010.00000100

B. 00000000.00000001.00000100

C. 00000001.10100010.00000100

D. 00000001.10100001.00000010

Related Questions

  1. Which of the following is true concerning ACLs?
  2. You are given a Class C network with a subnet mask of How many host addresses are there…
  3. You are given a Class C network, You need one network with 120 hostsand two networks…
  4. _________ negotiates the data link and network layer protocols that will traverse a PPP connection.
  5. Which type of traffic is sent to a group of devices?
  6. When choosing a networking product, you should consider all of the following except _______.
  7. ___________ defines LAPD, which is responsible for the data-link layer connection between the router…
  8. _________ has a physical star topology but a logical ring topology.
  9. _________ describe(s) users that can connect to a network from any location.
  10. The TCP/IP protocol stack has ________ layers.
  11. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  12. A ________ topology describes how devices communicate with each other.
  13. How many steps do LCP and NCP go through when setting up a connection?
  14. Which 2950 command enables trunking?
  15. A routing protocol that supports route summarization must perform all except which of the following?
  16. Extended traceroute works from which mode?
  17. The OSPF process ID is __________.
  18. Ethernet ___________ has/have both a physical and logical bus topology.
  19. Which of the following is stored in ROM? (Choose all correct answers.)
  20. Which of the following is true concerning full-duplexing?
  21. What router command saves the active configuration to NVRAM?
  22. With _________ switching, the switch reads the destination MAC address of the frame andimmediately starts…
  23. Which types of memory do not maintain their contents during a power-off state?
  24. Which is not one of the three main functions of a layer-2 device?
  25. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  26. Which router command performs an overwrite process? (Choose all correct answers.)
  27. IGRP generates an update every ___________ seconds.
  28. A _________ uses Gigabit Ethernet as a media type
  29. There are _________ actions a router can take when there is a match on an ACL statement
  30. Which of the following WAN categories does ISDN fall under?

Please do not use chat terms. Example: avoid using "grt" instead of "great".