Home

You execute the line console 0 command from Configuration mode. What will the router's prompt be?

A. Router(config)#

B. Router(config-line)#

C. Router(config-interface)#

D. Router#(config-if)

Related Questions

  1. 172.16.240.256 is a class __________ address.
  2. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  3. Which of the following are not features of ACLs?
  4. ________ topologies in NBMA environments do not have problems with split horizon.
  5. What command activates the IP routing process?
  6. On the 1900 switch, how do you enter User EXEC mode?
  7. _________ is/are a routed protocol.
  8. Which of the following is a disadvantage of SANs?
  9. A ________ topology describes how devices communicate with each other.
  10. IOS images can be loaded from all the following except:
  11. Which protocol supports VLSM?
  12. Which 2950 command assigns a VLAN to an interface?
  13. Which of the following is stored in ROM? (Choose all correct answers.)
  14. The 1900 switch supports ________ VLANs.
  15. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  16. OSPF supports a ________-layer hierarchical design.
  17. A routing protocol that supports route summarization must perform all except which of the following?
  18. RIP supports load balancing for up to __________ ___________ paths.
  19. Which 2950 command enables trunking?
  20. When configuring a router-on-a-stick, the configuration is done on __________.
  21. The address of a Frame Relay VC is called a ___________.
  22. When connecting a switch to a router, use a ___________ cable.
  23. When using the show interfaces command, which Frame Relay information can you not see?
  24. Which of the following reasons might you need to use address translation?
  25. The root switch is the one elected with the __________ __________.
  26. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  27. What uses 64 Kbps of bandwidth?
  28. The switch port that is chosen to forward traffic for a segment is called a __________.
  29. Which of the following is false concerning OSPF?
  30. OSPF hellos are sent every __________ seconds on a multi-access medium.

Please do not use chat terms. Example: avoid using "grt" instead of "great".