Home

You have a 24-channel T1 connection to your router. How many VCs does this T1 support?

A. 1

B. 24

C. No limit

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. _________ defines how the Frame Relay DTE and DCE interact with each other.
  2. RIP has a hold-down period of ____________ seconds.
  3. You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
  4. __________ allows you to distribute connection requests destined to a single IP address to multiple…
  5. Which of the following reasons might you need to use address translation?
  6. Which router command would you use to test only layer-3 connectivity?
  7. Which 2950 command enables trunking?
  8. When using the show interfaces command, which Frame Relay information can you not see?
  9. IGRP generates an update every ___________ seconds.
  10. What command assigns a User EXEC password to a 2950 switch?
  11. __________ states that if a neighboring router sends a route to a router, the receiving router will…
  12. When you have configured PPP on an interface and use the show interfaces command, what state indicates…
  13. If the 2950's RPS is ________, the external power supply is supplying power.
  14. A _________ uses Gigabit Ethernet as a media type
  15. Which command is used to define the local addresses that are statically translated to global addresses?
  16. Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing…
  17. The TCP/IP protocol stack has ________ layers.
  18. A _________ routes between different autonomous systems.
  19. IOS images can be loaded from all the following except:
  20. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  21. Which VTP mode(s) will propagate VTP messages?
  22. Which protocol supports VLSM?
  23. VLSM allows a network segment to have more than one subnet mask.
  24. Extended IP ACLs should be placed as close to the ____________ device as possible.
  25. Choose the following that a standard IP ACL can match on.
  26. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  27. What subnet mask would you use to set up a default route?
  28. VLSM allows you to summarize 192.168.2.0/24 and 192.168.3.0/24 as 192.168.2.0/25.
  29. The _________ command takes you from User EXEC mode to Privilege EXEC mode
  30. With _________ switching, the switch reads the destination MAC address of the frame andimmediately starts…