Engineering Drawing MCQ Question with Answer

Question No : 29
The thread note for a typical bolt will include the ________.

Question No : 30
When positioning this feature of perspective projection, the centerline of the cone of visual rays should be directed toward the approximate center of the object:

Question No : 31
The Press-Pull tool will ________ the face of a solid model in the direction it faces.

Question No : 32
These units are based on inch-foot and yard measurements:

Question No : 33
When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.

Question No : 34
This type of projection is when projectors are parallel to each other, but is at an angle other than 90 degrees to the plane of projection:

Question No : 35
When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.