Airport Engineering 1000+ MCQ with answer for RRB Group D

1. International Civil Aviation Organisation (I.C.A.O.) was set up at Montreal (Canada), in
A. 1929
B. 1939
C. 1947
D. 1950
Answer : C

2. Pick up the correct statement from the following:
A. The centre line of the approach area coincides with that of the runway
B. Approach areas are measured in horizontal surfaces
C. Obstruction clearance surface and approach surface are same
D. All the above
Answer : D

3. Pick up the incorrect statement from the following:
A. L.O.M. is installed at 7.2 km from the threshold
B. L.M.M. is installed at 1.0 km from the threshold
C. Localizer antenna is installed at 300 m from the other end of the runway
D. Glide slope antenna is installed at the centre of the runway about 150 m on one side
Answer : D

4. According to I.C.A.O. all markings on the runways are painted white and on taxiways
A. Black
B. Red
C. Yellow
D. Green
Answer : C

5. The width and interval of transverse centre line bars along the extended centre line of runway, in approach lighting system are
A. 3 m and 30 m
B. 4.2 m and 30 m
C. 4.2 m and 50 m
D. 3 m and 45 m
Answer : B

6. If lift off distance of an craft is 2000 m, the clear way at the end of the runway should not be less than
A. 145 m
B. 152.5 m
C. 162.5 m
D. 172.5 m
Answer : D

7. Pick up the correct statement from the following:
A. The distance between the points of intersection of the extreme tangents to the transition curve is kept greater than 7500 m × sum of grade changes at the point of intersection
B. The rate of change of grade is limited to 0.3% per 30 m length of the curve
C. According to I.C.A.O. the maximum longitudinal gradient along a runway is limited to 1.5%
D. All the above
Answer : D

8. Pick up the incorrect statement from the following:
A. In single engine aeroplanes, the engine is provided in the nose of the aircraft
B. In double engine aeroplanes, one engine on either wing is placed symmetrically
C. In three engine aeroplanes, two engines are placed on both wings and one engine is placed in the tail
D. None of these
Answer : C

9. The centre to centre spacing of heliport lighting along the periphery of landing and takeoff area should be
A. 2.5 m
B. 5.0 m
C. 7.5 m
D. 10.0 m
Answer : C

10. Calm period is the percentage of time during which wind intensity is less than
A. 4.8 kmph
B. 6.4 kmph
C. 8.0 kmph
D. 9.6 kmph
Answer : B

11. The runway orientation is made so that landing and takeoff are
A. Against the wind direction
B. Along the wind direction
C. Perpendicular to wind direction
D. None of these
Answer : A

12. Pick up the correct statement from the following:
A. Approximate geometric centre of the landing area, is called air port reference point
B. The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
C. The location of the air port on a map is the position of air port reference point
D. All the above
Answer : D

13. For the proposed runway stated in if the aerodrome reference temperature is 17°.2, the net designed length of the runway is
A. 2716 m
B. 2816 m
C. 2916 m
D. 3016 m
Answer : B

14. The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60°, the distance of centre of rotation from the nearer main gear, is
A. 12.30 m
B. 11.30 m
C. 10.30 m
D. 9.30 m
Answer : A

15. Which of the following is used for servicing and repairs of the aircraft?
A. Apron
B. Hanger
C. Terminal building
D. Holding apron
Answer : B

16. An airport has 4 gates. If the weighted average gate occupancy time is 30 minutes and gate utilisation factor is 0.5, then the capacity of the gate will be
A. 1 aircraft per hour
B. 2 aircrafts per hour
C. 4 aircrafts per hour
D. 16 aircrafts per hour
Answer : C

17. Pick up the component not applicable to aeroplanes
A. Wings
B. Engines
C. Air screw
D. None of these
Answer : D

18. Castor angle is defined as the angle
A. Formed by the longitudinal axis of the aircraft and the direction of movement of the nose gear
B. Between the direction of wind and the longitudinal axis of the runway
C. Between the true speed of the aircraft and the crosswind component
D. Between the horizontal and the fuselage axis
Answer : A

19. The reduced level of the proposed site of an air port is 2500 m above M.S.L. If the recommended length by I.C.A.O. for the runway at sea level is 2500 m, the required length of the runway is
A. 2500 m
B. 3725 m
C. 3000 m
D. 3250 m
Answer : B

20. For Class A Air port the difference of reduced levels o higher and lower edges of the conical surface, is
A. 25 m
B. 50 m
C. 75 m
D. 100 m
Answer : D

21. The meteorological condition which influences the size and location of an air port is
A. Atmosphere pressure
B. Air density
C. Reduced level
D. All the above
Answer : D

22. The engine failure case for determining the basic runway length may require
A. Only clearway
B. Only stop way
C. Either a clearway or a stop-way
D. Either a clearway or a stop-way or both
Answer : D

23. The slope of the transitional surface for A, B and C type of runway shall be
A. 1 : 5
B. 1 : 7
C. 1 : 10
D. 1 : 12
Answer : B

24. The maximum value of the angle of turning of the nose gear large jet aircrafts, is limited to
A. 20°
B. 30°
C. 45°
D. 60°
Answer : D

25. The air is blowing at a speed of 75 knots in the direction of the aircraft flying at a ground speed of 775 knots. The air speed of the aircraft, is
A. 775 knots
B. 75 knots
C. 850 knots
D. 675 knots
Answer : D

26. According to I.C.A.O. the slope of transitional surface at right angles to the centre line of runway, is kept
A. 1 in 4
B. 1 in 5
C. 1 in 6
D. 1 in 7
Answer : D

27. Pick up the correct statement from the following:
A. The basic length of a runway is increased at a rate of 7% per 300 m of elevation of M.S.L.
B. The standard temperature at the site is obtained by reducing the standard sea level temperature of 15°C at the rate of 6.5°C per 1000 m rise in elevation
C. The aerodrome reference temperature is the monthly mean of the mean daily temperature for the hottest month of the year
D. All the above
Answer : D

28. The coordinates of the ends of a runway are (5000, 5000) and (8000, 7000). The co-ordinates of another runway are (4600, 5100) and (7000, 5300). The co-ordinates of the A.R.P. are
A. (6500, 6000)
B. (5800, 5200)
C. (61500, 5600)
D. (8000, 7000)
Answer : C

29. Which of the following factors are taken into account for estimating the runway length required for aircraft landing?
1. Normal maximum temperature
2. Airport elevation
3. Maximum landing weight
4. Effective runway gradient Select the correct answer using the codes given below Codes:
A. 1, 2, 3 and 4
B. 1, 3 and 4
C. 2 and 3
D. 1, 2 and 4
Answer : D

30. For night landing, the thresholds are lighted
A. Green
B. Red
C. White
D. Yellow
Answer : A

31. According to the International Civil Aviation Organisation (I.C.A.O.) the strength of runway pavements, have been coded by
A. Seven English alphabets
B. Last Seven English alphabets
C. First Seven English alphabets
D. First seven numbers
Answer : D

32. In an airport, if 4 groups of 5 gates each located well separated are considered for traffic and the future to present traffic ratio is 3, then the total requirement of future gates will be
A. 32
B. 36
C. 44
D. 68
Answer : B

33. In instrument landing system
A. L.O.M. and L.M.M. are installed on one side and Localizer antenna on the other side
B. L.O.M. and Localizer are installed on one side and L.M.M. on the other side
C. Localizer and L.M.M. are installed on one side and L.O.M. on the other side
D. None of these
Answer : A

34. The length of a runway under standard atmospheric conditions is 1800 m. If the actual reduced level of the site is 1200 m, the design length of the runway is
A. 2360 m
B. 2460 m
C. 2560 m
D. 2660 m
Answer : C

35. Pick up the correct abbreviation from the following:
A. L.M.M. (low powered middle marker)
B. V.H.F, (very high frequency)
C. L.O.M. (low powered outer marker)
D. All the above
Answer : D

36. A gradient of + 0.08% is followed by a gradient of - 0.07%. If the permissible rate of change of grade is 0.003 per 30 metres, the length of the transition curve, is
A. 150 m
B. 140 m
C. 160 m
D. 175 m
Answer : A

37. As per ICAO recommendation, the rate of change of longitudinal gradient per 30 m length of vertical curve for A and B type of airports is limited to a maximum of
A. 0.1 %
B. 0.2 %
C. 0.3 %
D. 0.4 %
Answer : A

38. As per UK design criteria, if LCN of aircraft is between 1.25 to 1.5 times the LCN of pavement, then the number of movements allowed are
A. Zero
B. 300
C. 3000
D. Unrestricted
Answer : B

39. The reduced levels of the ends A and B of a runway are 3025 m and 3035 m and that of its mid-point is 3015 m. The reduced level of the horizontal surface, is
A. 3070 m
B. 3060 m
C. 3075 m
D. 3015 m
Answer : C

40. The main disadvantage of angle nose out parking configuration of aircraft is that the
A. Aircraft rear loading door is far away from terminal building.
B. Hot blast is directed towards the terminal building
C. Overall apron area required is more
D. All the above
Answer : B

41. The maximum length and pavement strength of the runway is that of
A. A 1
B. B 2
C. B 3
D. G 7
Answer : A

42. The fuse large includes
A. Passengers chamber
B. Pilot's cabin
C. Tail of aircraft
D. All the above
Answer : D

43. Assertion A : Airport capacity during IFR conditions is usually less than that during VFR conditions. Reason R: During clear weather condition (VFR), the aircrafts on final approach to runway can be spaced closer during poor visibility conditions. Select your answer based on the coding system given below:
A. Both A and R is true and R is the correct explanation of A
B. Both A and R is true but R is not the correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer : A

44. In approach areas of runways equipped with instrumental landing facilities any object within 4.5 km distance from runway end shall be considered as an obstruction if its height is more than
A. 20 m
B. 30 m
C. 45 m
D. 51 m
Answer : B

45. Consider the following statements regarding ICAO recommendation for correction to basic runway length
1. The basic runway length should be increased at the rate of 7 percent per 300 m rise in elevation above the mean sea level.
2. The basic runway length after having been corrected for elevation should be further increased at the rate of 1 percent for every 1°C rise in airport reference temperature above the standard atmospheric temperature at that elevation.
3. The runway length after having been corrected for elevation and temperature should be further increased at the rate of 20% for every 1 percent of effective gradient. Of these statements
A. 1 and 2 are correct
B. 2 and 3 are correct
C. 1 and 3 are correct
D. 1, 2 and 3 are correct
Answer : A

46. For the taxiways, the following statement is true
A. The maximum longitudinal grade is 3%
B. The permissible rate of change of grade is 1%
C. The permissible transverse grade is 1.5%
D. All the above
Answer : D

47. Speed of
A. Sound at 0°C is 1190 kmph
B. Sound varies 2.4 kmph per degree centigrade rise in temperature
C. Sound at 0°C is called one Mach
D. All the above
Answer : D

48. According to ICAO, all markings on the runways are
A. Yellow
B. White
C. Black
D. Red
Answer : B

49. Pick up the incorrect statement from the following:
A. Channelization of pavement is caused by constant use of tri-cycle gears of aircraft
B. Blast pads are used over cohesionless soils to resist erosion due to tremendous speed of the jet blast
C. Over-run areas of at least 300 m length on either side of the runway are provided
D. None of these
Answer : D

50. For supersonic transport aircraft, the minimum turning radius of taxiway is
A. 60 m
B. 120 m
C. 180 m
D. 240 m
Answer : C