Airport Engineering MCQ Solved Paper for DRDO

1. Pick up the correct statement from the following:
A. Runway edge from the landing side, is called threshold
B. Localizer indicates to the pilot his position with respect to the proposed alignment
C. The glide slope indicates the correct angle of descent
D. All the above
Answer : D

2. In Intrumental landing system, the middle markers are located
A. Along the extended centre line of runway end
B. About 1 km. ahead of the runway threshold
C. At the runway threshold
D. About 7 km. ahead of the runway threshold
Answer : B

3. Consider the following statements: Wind rose diagram is used for the purposes of
1. Runway orientation
2. Estimating the runway capacity
3. Geometric design of holding apron of these statements
A. 1 and 2 are correct
B. 2 and 3 are correct
C. 1 and 3 are correct
D. 1 alone is correct
Answer : D

4. In an airport, if 4 groups of 5 gates each located well separated are considered for traffic and the future to present traffic ratio is 3, then the total requirement of future gates will be
A. 32
B. 36
C. 44
D. 68
Answer : B

5. According to I.C.A.O. the slope of transitional surface at right angles to the centre line of runway, is kept
A. 1 in 4
B. 1 in 5
C. 1 in 6
D. 1 in 7
Answer : D

6. Effective length of a runway is the distance between
A. Ends of the runway
B. Point of intersection of the obstruction clearance line and the extended plane of the runway surface, and the other end of the runway
C. Point of intersection of the glide path and the extended plane of the runway surface and the other end of the runway
D. Ends of the clear way on either side
Answer : B

7. The best direction of a runway is along the direction of
A. Longest line on wind rose diagram
B. Shortest line on the wind rose diagram
C. Line clear of wind rose diagram
D. None of these
Answer : A

8. The reduced levels of the ends A and B of a runway are 3025 m and 3035 m and that of its mid-point is 3015 m. The reduced level of the horizontal surface, is
A. 3070 m
B. 3060 m
C. 3075 m
D. 3015 m
Answer : C

9. Consider the following statements regarding ICAO recommendation for correction to basic runway length
1. The basic runway length should be increased at the rate of 7 percent per 300 m rise in elevation above the mean sea level.
2. The basic runway length after having been corrected for elevation should be further increased at the rate of 1 percent for every 1°C rise in airport reference temperature above the standard atmospheric temperature at that elevation.
3. The runway length after having been corrected for elevation and temperature should be further increased at the rate of 20% for every 1 percent of effective gradient. Of these statements
A. 1 and 2 are correct
B. 2 and 3 are correct
C. 1 and 3 are correct
D. 1, 2 and 3 are correct
Answer : A

10. Assertion A : The ratio of arriving and departing aircrafts influences the airport Capacity: Reason R : Landing operation is generally given priority over the taking off operation. Select your answer based on the coding system given below:
A. Both A and R is true and R is the correct explanation of A
B. Both A and R is true and R is not the correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer : A

11. Pick up the correct statement from the following:
A. The basic length of a runway is increased at a rate of 7% per 300 m of elevation of M.S.L.
B. The standard temperature at the site is obtained by reducing the standard sea level temperature of 15°C at the rate of 6.5°C per 1000 m rise in elevation
C. The aerodrome reference temperature is the monthly mean of the mean daily temperature for the hottest month of the year
D. All the above
Answer : D

12. Castor angle is defined as the angle
A. Formed by the longitudinal axis of the aircraft and the direction of movement of the nose gear
B. Between the direction of wind and the longitudinal axis of the runway
C. Between the true speed of the aircraft and the crosswind component
D. Between the horizontal and the fuselage axis
Answer : A

13. The maximum value of the angle of turning of the nose gear large jet aircrafts, is limited to
A. 20°
B. 30°
C. 45°
D. 60°
Answer : D

14. An airport has 4 gates. If the weighted average gate occupancy time is 30 minutes and gate utilisation factor is 0.5, then the capacity of the gate will be
A. 1 aircraft per hour
B. 2 aircrafts per hour
C. 4 aircrafts per hour
D. 16 aircrafts per hour
Answer : C

15. The length of runway under standard conditions is 2000 m. The elevation of airport site is 300 m. Its reference temperature is 33.05°C. If the runway is to be constructed with an effective gradient of 0.25 percent, the corrected runway length will be
A. 2500 m
B. 2600 m
C. 2700 m
D. 2800 m
Answer : C

16. As per ICAO recommendation, minimum width of safety area for instrumental runway should be
A. 78 m
B. 150 m
C. 300 m
D. 450 m
Answer : C

17. Pick up the correct statement from the following:
A. Air screw converts the energy given by the engine into speed
B. The propellers which are driven by turbine engines, are technically called turboprops
C. The aircrafts which obtain the thrust directly from turbine engine, are called turbo-jets
D. All the above
Answer : D

18. As per ICAO recommendation, the rate of change of longitudinal gradient per 30 m length of vertical curve for A and B type of airports is limited to a maximum of
A. 0.1 %
B. 0.2 %
C. 0.3 %
D. 0.4 %
Answer : A

19. Airport elevation is the reduced level above M.S.L. of
A. Control tower
B. Highest point of the landing area
C. Lowest point of the landing area
D. None of these
Answer : B

20. The total length of a runway is 1000 m. The elevation at distance 0,200 m, 400 m, 600 m, 800 m and 1000 m are 100.0 m, 99.2 m, 101.0 m, 101.8 m, 101.4 m and 101.0 m respectively. The effective gradient of runway will be.
A. 0.10 %
B. 0.26 %
C. 0.43 %
D. 0.65 %
Answer : B

21. The capacity of parallel runway pattern depends upon
A. Weather conditions and navigational aids available
B. Lateral spacing between two runways and weather conditions
C. Lateral spacing between two runways and navigational aids available
D. Lateral spacing between two runways, weather conditions and navigational aids available.
Answer : D

22. As per ICAO, for A, B, and C type of airports, maximum effective, transverse and longitudinal grades in percentage respectively are
A. 1.0, 1.5 and 1.5
B. 1.0, 1.5 and 2.0
C. 1.5, 1.5 and 2.0
D. 2.0, 2.0 and 2.0
Answer : A

23. The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60°, the distance of centre of rotation from the nearer main gear, is
A. 12.30 m
B. 11.30 m
C. 10.30 m
D. 9.30 m
Answer : A

24. Pick up the incorrect statement from the following:
A. Channelization of pavement is caused by constant use of tri-cycle gears of aircraft
B. Blast pads are used over cohesionless soils to resist erosion due to tremendous speed of the jet blast
C. Over-run areas of at least 300 m length on either side of the runway are provided
D. None of these
Answer : D

25. Pick up the correct statement from the following:
A. Landing speed is directly proportional to the wing loading
B. Wing loading remaining constant, the take off distance is directly proportional to the powder loading
C. Neither (a) nor (b)
D. Both (a) and (b)
Answer : D

26. The width and interval of transverse centre line bars along the extended centre line of runway, in approach lighting system are
A. 3 m and 30 m
B. 4.2 m and 30 m
C. 4.2 m and 50 m
D. 3 m and 45 m
Answer : B

27. According to ICAO, all markings on the runways are
A. Yellow
B. White
C. Black
D. Red
Answer : B

28. The main disadvantage of angle nose out parking configuration of aircraft is that the
A. Aircraft rear loading door is far away from terminal building.
B. Hot blast is directed towards the terminal building
C. Overall apron area required is more
D. All the above
Answer : B

29. Pick up the correct statement from the following:
A. The centre line of the approach area coincides with that of the runway
B. Approach areas are measured in horizontal surfaces
C. Obstruction clearance surface and approach surface are same
D. All the above
Answer : D

30. Pick up the component not applicable to aeroplanes
A. Wings
B. Engines
C. Air screw
D. None of these
Answer : D

31. Which of the following is used for servicing and repairs of the aircraft?
A. Apron
B. Hanger
C. Terminal building
D. Holding apron
Answer : B

32. The engine failure case for determining the basic runway length may require
A. Only clearway
B. Only stop way
C. Either a clearway or a stop-way
D. Either a clearway or a stop-way or both
Answer : D

33. Pick up the correct statement from the following:
A. Tar concrete pavements are suitable if fuel spillage occurs
B. Rubberised tar concrete hot blast as well as spillage
C. Epoxy asphalt concrete sets in very small time
D. All the above
Answer : D

34. A gradient of + 0.08% is followed by a gradient of - 0.07%. If the permissible rate of change of grade is 0.003 per 30 metres, the length of the transition curve, is
A. 150 m
B. 140 m
C. 160 m
D. 175 m
Answer : A

35. As per UK design criteria, if LCN of aircraft is between 1.25 to 1.5 times the LCN of pavement, then the number of movements allowed are
A. Zero
B. 300
C. 3000
D. Unrestricted
Answer : B

36. Zero fuel weight of an aircraft is:
A. Equal to empty operating weight
B. Equal to maximum landing weight
C. Less than empty operating weight
D. Equal to sum of empty operating weight and the maximum pay load
Answer : D

37. Speed of
A. Sound at 0°C is 1190 kmph
B. Sound varies 2.4 kmph per degree centigrade rise in temperature
C. Sound at 0°C is called one Mach
D. All the above
Answer : D

38. Assertion A: The width of a taxiway is smaller than the runway width. Reason R: The speed of the aircraft on a taxiway is greater than that on runway. Select your answer based on coding system given below
A. Both A and R is true and R is the correct explanation of A
B. Both A and R is true but R is not the correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer : C

39. Which of the following is an example of failure in flexible pavements?
A. Alligator cracking
B. Mud pumping
C. Warping cracks
D. Shrinkage cracks
Answer : A

40. The strength of winds is measured with the help of
A. Beaufort scale
B. Wind indicator
C. Barometers
D. None of these
Answer : A

41. The runway orientation is made so that landing and takeoff are
A. Against the wind direction
B. Along the wind direction
C. Perpendicular to wind direction
D. None of these
Answer : A

42. Pick up the correct statement from the following:
A. Minimum turning radius of aircrafts decides the size of the apron and the radius of the curves at taxi-ends
B. Take off and landing distances for an aircraft, determine the minimum runway length
C. The length of the normal haul of the air craft decides the frequency of operation
D. All the above
Answer : D

43. For Class A Air port the difference of reduced levels of higher and lower edges of the conical surface, is
A. 25 m
B. 50 m
C. 75 m
D. 100 m
Answer : D

44. The reduced level of the proposed site of an air port is 2500 m above M.S.L. If the recommended length by I.C.A.O. for the runway at sea level is 2500 m, the required length of the runway is
A. 2500 m
B. 3725 m
C. 3000 m
D. 3250 m
Answer : B

45. The air is blowing at a speed of 75 knots in the direction of the aircraft flying at a ground speed of 775 knots. The air speed of the aircraft, is
A. 775 knots
B. 75 knots
C. 850 knots
D. 675 knots
Answer : D

46. The slope of the transitional surface for A, B and C type of runway shall be
A. 1 : 5
B. 1 : 7
C. 1 : 10
D. 1 : 12
Answer : B

47. Assertion A : Airport capacity during IFR conditions is usually less than that during VFR conditions. Reason R: During clear weather condition (VFR), the aircrafts on final approach to runway can be spaced closer during poor visibility conditions. Select your answer based on the coding system given below:
A. Both A and R is true and R is the correct explanation of A
B. Both A and R is true but R is not the correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer : A

48. Pick up the correct statement from the following:
A. Approximate geometric centre of the landing area, is called air port reference point
B. The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
C. The location of the air port on a map is the position of air port reference point
D. All the above
Answer : D

49. The fuse large includes
A. Passengers chamber
B. Pilot's cabin
C. Tail of aircraft
D. All the above
Answer : D

50. For the taxiways, the following statement is true
A. The maximum longitudinal grade is 3%
B. The permissible rate of change of grade is 1%
C. The permissible transverse grade is 1.5%
D. All the above
Answer : D