Airport Engineering MCQ Solved Paper for SSC Scientific Assistant

1. Pick up the correct statement from the following:
A. The distance between the points of intersection of the extreme tangents to the transition curve is kept greater than 7500 m × sum of grade changes at the point of intersection
B. The rate of change of grade is limited to 0.3% per 30 m length of the curve
C. According to I.C.A.O. the maximum longitudinal gradient along a runway is limited to 1.5%
D. All the above
Answer : D

2. The length of a runway under standard atmospheric conditions is 1800 m. If the actual reduced level of the site is 1200 m, the design length of the runway is
A. 2360 m
B. 2460 m
C. 2560 m
D. 2660 m
Answer : C

3. For the taxiways, the following statement is true
A. The maximum longitudinal grade is 3%
B. The permissible rate of change of grade is 1%
C. The permissible transverse grade is 1.5%
D. All the above
Answer : D

4. The maximum value of the angle of turning of the nose gear large jet aircrafts, is limited to
A. 20°
B. 30°
C. 45°
D. 60°
Answer : D

5. In an airport, if 4 groups of 5 gates each located well separated are considered for traffic and the future to present traffic ratio is 3, then the total requirement of future gates will be
A. 32
B. 36
C. 44
D. 68
Answer : B

6. Which of the following is an example of failure in flexible pavements?
A. Alligator cracking
B. Mud pumping
C. Warping cracks
D. Shrinkage cracks
Answer : A

7. The lift off distance is the distance along the centre of the runway between the starting point and
A. End of the runway
B. End of stop-way
C. Point where air craft becomes air borne
D. Point where air craft attains a height of 10.7 m
Answer : A

8. According to ICAO, all markings on the runways are
A. Yellow
B. White
C. Black
D. Red
Answer : B

9. Pick up the correct statement from the following:
A. The centre line of the approach area coincides with that of the runway
B. Approach areas are measured in horizontal surfaces
C. Obstruction clearance surface and approach surface are same
D. All the above
Answer : D

10. According to the International Civil Aviation Organisation (I.C.A.O.), the runway lengths of aerodromes, have been coded by
A. Seven English alphabets
B. Last Seven English alphabets
C. First Seven English alphabets
D. First seven natural numbers
Answer : C

11. Assertion A : Airport capacity during IFR conditions is usually less than that during VFR conditions. Reason R: During clear weather condition (VFR), the aircrafts on final approach to runway can be spaced closer during poor visibility conditions. Select your answer based on the coding system given below:
A. Both A and R is true and R is the correct explanation of A
B. Both A and R is true but R is not the correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer : A

12. As per ICAO, the minimum basic runway length for A and E type of airport will be
A. 1500 m and 600 m
B. 2100 m and 750 m
C. 1500 m and 750 m
D. 2100 m and 600 m
Answer : D

13. For the proposed runway stated in if the aerodrome reference temperature is 17°.2, the net designed length of the runway is
A. 2716 m
B. 2816 m
C. 2916 m
D. 3016 m
Answer : B

14. As per ICAO, for airports serving big aircrafts, the crosswind component should not exceed
A. 15 kmph
B. 25 kmph
C. 35 kmph
D. 45 kmph
Answer : C

15. According to the International Civil Aviation Organisation (I.C.A.O.) the strength of runway pavements, have been coded by
A. Seven English alphabets
B. Last Seven English alphabets
C. First Seven English alphabets
D. First seven numbers
Answer : D

16. The meteorological condition which influences the size and location of an air port is
A. Atmosphere pressure
B. Air density
C. Reduced level
D. All the above
Answer : D

17. As per ICAO recommendation, the rate of change of longitudinal gradient per 30 m length of vertical curve for A and B type of airports is limited to a maximum of
A. 0.1 %
B. 0.2 %
C. 0.3 %
D. 0.4 %
Answer : A

18. For night landing, the thresholds are lighted
A. Green
B. Red
C. White
D. Yellow
Answer : A

19. The size of landing area for multi engine helicopters operating under 1 FR conditions is
A. 22.5 m × 22.5 m
B. 30 m × 30 m
C. 22.5 m × 30 m
D. 60 m × 120 m
Answer : D

20. In approach areas of runways equipped with instrumental landing facilities any object within 4.5 km distance from runway end shall be considered as an obstruction if its height is more than
A. 20 m
B. 30 m
C. 45 m
D. 51 m
Answer : B

21. The width and interval of transverse centre line bars along the extended centre line of runway, in approach lighting system are
A. 3 m and 30 m
B. 4.2 m and 30 m
C. 4.2 m and 50 m
D. 3 m and 45 m
Answer : B

22. Two single runways may be arranged so as to have
A. L-shape
B. T-shape
C. X-shape
D. All the above
Answer : D

23. The total length of a runway is 1000 m. The elevation at distance 0,200 m, 400 m, 600 m, 800 m and 1000 m are 100.0 m, 99.2 m, 101.0 m, 101.8 m, 101.4 m and 101.0 m respectively. The effective gradient of runway will be.
A. 0.10 %
B. 0.26 %
C. 0.43 %
D. 0.65 %
Answer : B

24. The cruising speed of the aircraft is 500 kmph. If there is a head wind of 50 kmph, then the air speed and ground speed of the aircraft respectively will be
A. 450 kmph and 500 kmph
B. 500 kmph and 450 kmph
C. 450 kmph and 450 kmph
D. 500 kmph and 500 kmph
Answer : A

25. Total correction for elevation, temperature and gradient for a runway should not be more than
A. 15 %
B. 20 %
C. 25 %
D. 35 %
Answer : D

26. The main disadvantage of angle nose out parking configuration of aircraft is that the
A. Aircraft rear loading door is far away from terminal building.
B. Hot blast is directed towards the terminal building
C. Overall apron area required is more
D. All the above
Answer : B

27. An aircraft is flying in an atmosphere of 30°C with a speed of 1260 km ph. Its speed is known as
A. Subsonic
B. Sonic
C. Super-sonic
D. Mach
Answer : B

28. Pick up the correct statement from the following:
A. Tar concrete pavements are suitable if fuel spillage occurs
B. Rubberised tar concrete hot blast as well as spillage
C. Epoxy asphalt concrete sets in very small time
D. All the above
Answer : D

29. Pick up the correct statement from the following:
A. Minimum turning radius of aircrafts decides the size of the apron and the radius of the curves at taxi-ends
B. Take off and landing distances for an aircraft, determine the minimum runway length
C. The length of the normal haul of the air craft decides the frequency of operation
D. All the above
Answer : D

30. Pick up the correct statement from the following:
A. Air screw converts the energy given by the engine into speed
B. The propellers which are driven by turbine engines, are technically called turboprops
C. The aircrafts which obtain the thrust directly from turbine engine, are called turbo-jets
D. All the above
Answer : D

31. Castor angle is defined as the angle
A. Formed by the longitudinal axis of the aircraft and the direction of movement of the nose gear
B. Between the direction of wind and the longitudinal axis of the runway
C. Between the true speed of the aircraft and the crosswind component
D. Between the horizontal and the fuselage axis
Answer : A

32. Pick up the incorrect statement from the following:
A. Channelization of pavement is caused by constant use of tri-cycle gears of aircraft
B. Blast pads are used over cohesionless soils to resist erosion due to tremendous speed of the jet blast
C. Over-run areas of at least 300 m length on either side of the runway are provided
D. None of these
Answer : D

33. The landing and takeoff of the air craft is made against the direction of wind. In no case the centre line of the runway should make an angle with the wind direction exceeding
A. 10°
B. 20°
C. 30°
D. 40°
Answer : C

34. The coordinates of the ends of a runway are (5000, 5000) and (8000, 7000). The co-ordinates of another runway are (4600, 5100) and (7000, 5300). The co-ordinates of the A.R.P. are
A. (6500, 6000)
B. (5800, 5200)
C. (61500, 5600)
D. (8000, 7000)
Answer : C

35. The length of runway is increased per 300 m rise above M.S.L.
A. 3 %
B. 4 %
C. 5 %
D. 7 %
Answer : D

36. Effective length of a runway is the distance between
A. Ends of the runway
B. Point of intersection of the obstruction clearance line and the extended plane of the runway surface, and the other end of the runway
C. Point of intersection of the glide path and the extended plane of the runway surface and the other end of the runway
D. Ends of the clear way on either side
Answer : B

37. For Class A Air port the difference of reduced levels of higher and lower edges of the conical surface, is
A. 25 m
B. 50 m
C. 75 m
D. 100 m
Answer : D

38. The bearing of the runway at threshold is 290°, the runway number is
A. N 70° W
B. 290°
C. 29°
D. W 20° N
Answer : C

39. The length of runway under standard conditions is 2000 m. The elevation of airport site is 300 m. Its reference temperature is 33.05°C. If the runway is to be constructed with an effective gradient of 0.25 percent, the corrected runway length will be
A. 2500 m
B. 2600 m
C. 2700 m
D. 2800 m
Answer : C

41. Airport elevation is the reduced level above M.S.L. of
A. Control tower
B. Highest point of the landing area
C. Lowest point of the landing area
D. None of these
Answer : B

42. Runway threshold is indicated by a series of parallel lines starting from a distance of
A. 3 m from runway end
B. 6 m from runway end
C. 10 m from runway end
D. 15 m from runway end
Answer : B

43. Pick up the correct statement from the following:
A. F.I.R. stands for flight information regions
B. Radius of control area is 160 km
C. Radius of control zone is 40 km
D. All the above
Answer : D

44. The depressions and undulations in the pavement, are caused due to
A. Improper compaction of sub-grade
B. Impact of heavy wheel loads
C. Punching effect
D. All the above
Answer : D

45. The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60°, the distance of centre of rotation from the nearer main gear, is
A. 12.30 m
B. 11.30 m
C. 10.30 m
D. 9.30 m
Answer : A

46. The engine failure case for determining the basic runway length may require
A. Only clearway
B. Only stop way
C. Either a clearway or a stop-way
D. Either a clearway or a stop-way or both
Answer : D

47. Conical surface of the approach area rises outwards
A. 1 in 10
B. 1 in 15
C. 1 in 20
D. 1 in 25
Answer : C

48. Pick up the incorrect statement from the following:
A. In single engine aeroplanes, the engine is provided in the nose of the aircraft
B. In double engine aeroplanes, one engine on either wing is placed symmetrically
C. In three engine aeroplanes, two engines are placed on both wings and one engine is placed in the tail
D. None of these
Answer : C

49. Which of the following factors are taken into account for estimating the runway length required for aircraft landing?
1. Normal maximum temperature
2. Airport elevation
3. Maximum landing weight
4. Effective runway gradient Select the correct answer using the codes given below Codes:
A. 1, 2, 3 and 4
B. 1, 3 and 4
C. 2 and 3
D. 1, 2 and 4
Answer : D

50. The height of the pilot's eye above the runway surface is assumed
A. 1 m
B. 3 m
C. 4 m
D. 5 m
Answer : B