CLAT PG - Airport Engineering 1000+ MCQ [Solved] PDF Download

1. The slope of the obstruction clearance line from the boundary of the heliport should be
A. 1 : 2
B. 1 : 5
C. 1 : 8
D. 1 : 40
Answer : C

2. Castor angle is defined as the angle
A. Formed by the longitudinal axis of the aircraft and the direction of movement of the nose gear
B. Between the direction of wind and the longitudinal axis of the runway
C. Between the true speed of the aircraft and the crosswind component
D. Between the horizontal and the fuselage axis
Answer : A

3. The bearing of the runway at threshold is 290°, the runway number is
A. N 70° W
B. 290°
C. 29°
D. W 20° N
Answer : C

4. In instrument landing system
A. L.O.M. and L.M.M. are installed on one side and Localizer antenna on the other side
B. L.O.M. and Localizer are installed on one side and L.M.M. on the other side
C. Localizer and L.M.M. are installed on one side and L.O.M. on the other side
D. None of these
Answer : A

5. As per ICAO recommendation, the rate of change of longitudinal gradient per 30 m length of vertical curve for A and B type of airports is limited to a maximum of
A. 0.1 %
B. 0.2 %
C. 0.3 %
D. 0.4 %
Answer : A

6. In approach areas of runways equipped with instrumental landing facilities any object within 4.5 km distance from runway end shall be considered as an obstruction if its height is more than
A. 20 m
B. 30 m
C. 45 m
D. 51 m
Answer : B

7. Pick up the correct statement from the following:
A. Runway edge from the landing side, is called threshold
B. Localizer indicates to the pilot his position with respect to the proposed alignment
C. The glide slope indicates the correct angle of descent
D. All the above
Answer : D

8. Assertion A: The width of a taxiway is smaller than the runway width. Reason R: The speed of the aircraft on a taxiway is greater than that on runway. Select your answer based on coding system given below
A. Both A and R is true and R is the correct explanation of A
B. Both A and R is true but R is not the correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer : C

9. For the proposed air port, the survey project provides
A. Master plan
B. Topographic plan
C. Grading plan
D. All the above
Answer : D

10. The depressions and undulations in the pavement, are caused due to
A. Improper compaction of sub-grade
B. Impact of heavy wheel loads
C. Punching effect
D. All the above
Answer : D

11. According to I.C.A.O. the recommended length of air ports is decided on
A. Sea level elevation
B. Standard sea level temperature (15°C)
C. Effective gradient percentage
D. All the above
Answer : D

12. The length of runway under standard conditions is 2000 m. The elevation of airport site is 300 m. Its reference temperature is 33.05°C. If the runway is to be constructed with an effective gradient of 0.25 percent, the corrected runway length will be
A. 2500 m
B. 2600 m
C. 2700 m
D. 2800 m
Answer : C

13. For night landing, the thresholds are lighted
A. Green
B. Red
C. White
D. Yellow
Answer : A

14. Beaufort scale is used to determine
A. Strength of winds
B. Direction of winds
C. Height of air-crafts
D. None of these
Answer : A

15. From the end of an instrumental runway, the approach surface rises outwards
A. 1 in 20
B. 1 in 30
C. 1 in 40
D. 1 in 50
Answer : D

16. Pick up the correct statement from the following:
A. Minimum turning radius of aircrafts decides the size of the apron and the radius of the curves at taxi-ends
B. Take off and landing distances for an aircraft, determine the minimum runway length
C. The length of the normal haul of the air craft decides the frequency of operation
D. All the above
Answer : D

17. As per ICAO, for A, B, and C type of airports, maximum effective, transverse and longitudinal grades in percentage respectively are
A. 1.0, 1.5 and 1.5
B. 1.0, 1.5 and 2.0
C. 1.5, 1.5 and 2.0
D. 2.0, 2.0 and 2.0
Answer : A

18. Pick up the incorrect statement from the following:
A. In single engine aeroplanes, the engine is provided in the nose of the aircraft
B. In double engine aeroplanes, one engine on either wing is placed symmetrically
C. In three engine aeroplanes, two engines are placed on both wings and one engine is placed in the tail
D. None of these
Answer : C

19. The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60°, the distance of centre of rotation from the nearer main gear, is
A. 12.30 m
B. 11.30 m
C. 10.30 m
D. 9.30 m
Answer : A

20. Total correction for elevation, temperature and gradient for a runway should not be more than
A. 15 %
B. 20 %
C. 25 %
D. 35 %
Answer : D

21. Zero fuel weight of an aircraft is:
A. Equal to empty operating weight
B. Equal to maximum landing weight
C. Less than empty operating weight
D. Equal to sum of empty operating weight and the maximum pay load
Answer : D

22. According to ICAO, all markings on the runways are
A. Yellow
B. White
C. Black
D. Red
Answer : B

23. As per ICAO recommendation, minimum width of safety area for instrumental runway should be
A. 78 m
B. 150 m
C. 300 m
D. 450 m
Answer : C

24. Pick up the correct statement from the following:
A. F.I.R. stands for flight information regions
B. Radius of control area is 160 km
C. Radius of control zone is 40 km
D. All the above
Answer : D

25. Airport elevation is the reduced level above M.S.L. of
A. Control tower
B. Highest point of the landing area
C. Lowest point of the landing area
D. None of these
Answer : B

26. The slope of the transitional surface for A, B and C type of runway shall be
A. 1 : 5
B. 1 : 7
C. 1 : 10
D. 1 : 12
Answer : B

27. Consider the following statements regarding ICAO recommendation for correction to basic runway length
1. The basic runway length should be increased at the rate of 7 percent per 300 m rise in elevation above the mean sea level.
2. The basic runway length after having been corrected for elevation should be further increased at the rate of 1 percent for every 1°C rise in airport reference temperature above the standard atmospheric temperature at that elevation.
3. The runway length after having been corrected for elevation and temperature should be further increased at the rate of 20% for every 1 percent of effective gradient. Of these statements
A. 1 and 2 are correct
B. 2 and 3 are correct
C. 1 and 3 are correct
D. 1, 2 and 3 are correct
Answer : A

28. The length of clear zone for none instrument runway of a small aircraft is
A. 150 m
B. 300 m
C. 600 m
D. 750 m
Answer : B

29. The maximum value of the angle of turning of the nose gear large jet aircrafts, is limited to
A. 20°
B. 30°
C. 45°
D. 60°
Answer : D

30. Effective length of a runway is the distance between
A. Ends of the runway
B. Point of intersection of the obstruction clearance line and the extended plane of the runway surface, and the other end of the runway
C. Point of intersection of the glide path and the extended plane of the runway surface and the other end of the runway
D. Ends of the clear way on either side
Answer : B

31. For supersonic transport aircraft, the minimum turning radius of taxiway is
A. 60 m
B. 120 m
C. 180 m
D. 240 m
Answer : C

32. Pick up the component not applicable to aeroplanes
A. Wings
B. Engines
C. Air screw
D. None of these
Answer : D

33. Assertion A : Airport capacity during IFR conditions is usually less than that during VFR conditions. Reason R: During clear weather condition (VFR), the aircrafts on final approach to runway can be spaced closer during poor visibility conditions. Select your answer based on the coding system given below:
A. Both A and R is true and R is the correct explanation of A
B. Both A and R is true but R is not the correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer : A

34. The minimum width of clearway is
A. 50 m
B. 100 m
C. 150 m
D. 250 m
Answer : C

35. Wing loading of an aircraft is
A. Load of the wings
B. Gross total weight of the aircraft/ load of the wings
C. Gross total weight of the aircraft/ wing area
D. Gross total weight of the aircraft/total available H.P of engines
Answer : C

36. According to the International Civil Aviation Organisation (I.C.A.O.), the runway lengths of aerodromes, have been coded by
A. Seven English alphabets
B. Last Seven English alphabets
C. First Seven English alphabets
D. First seven natural numbers
Answer : C

37. As per ICAO, the minimum basic runway length for A and E type of airport will be
A. 1500 m and 600 m
B. 2100 m and 750 m
C. 1500 m and 750 m
D. 2100 m and 600 m
Answer : D

38. The reduced level of the proposed site of an air port is 2500 m above M.S.L. If the recommended length by I.C.A.O. for the runway at sea level is 2500 m, the required length of the runway is
A. 2500 m
B. 3725 m
C. 3000 m
D. 3250 m
Answer : B

39. Conical surface of the approach area rises outwards
A. 1 in 10
B. 1 in 15
C. 1 in 20
D. 1 in 25
Answer : C

40. The meteorological condition which influences the size and location of an air port is
A. Atmosphere pressure
B. Air density
C. Reduced level
D. All the above
Answer : D

41. The threshold markings are
A. 4 m wide
B. 1 m clear space between adjacent
C. Placed symmetrically on either side of the runway centre line
D. All the above
Answer : D

42. As per ICAO, for airports serving big aircrafts, the crosswind component should not exceed
A. 15 kmph
B. 25 kmph
C. 35 kmph
D. 45 kmph
Answer : C

43. Which of the following is used for servicing and repairs of the aircraft?
A. Apron
B. Hanger
C. Terminal building
D. Holding apron
Answer : B

44. The strength of winds is measured with the help of
A. Beaufort scale
B. Wind indicator
C. Barometers
D. None of these
Answer : A

45. For the taxiways, the following statement is true
A. The maximum longitudinal grade is 3%
B. The permissible rate of change of grade is 1%
C. The permissible transverse grade is 1.5%
D. All the above
Answer : D

46. The thickness design of the pavement, is decided on the load carried by
A. Main gears
B. Nose wheel
C. Tail wheel
D. All the above
Answer : A

47. Maximum gross takeoff weight of an aircraft is
A. Equal to the maximum structural landing weight
B. Less than the maximum structural landing weight
C. More than the maximum structural landing weight
D. Equal to the empty operating weight plus the payload
Answer : C

48. Which of the following is an example of failure in flexible pavements?
A. Alligator cracking
B. Mud pumping
C. Warping cracks
D. Shrinkage cracks
Answer : A

49. If the monthly mean of average daily temperature for the hottest month of the year is 25°C and the monthly mean of the maximum daily temperature of the same month of the year is 46°C, the airport reference temperature is
A. 32°C
B. 35.5°C
C. 48°C
D. 25°C
Answer : C

50. The engine failure case for determining the basic runway length may require
A. Only clearway
B. Only stop way
C. Either a clearway or a stop-way
D. Either a clearway or a stop-way or both
Answer : D