Heat & Mass Transfer MCQ Solved Paper for GATE

1. The heat is transferred by conduction, convection and radiation in
A. Melting of ice
B. Boiler furnaces
C. Condensation of steam in condenser
D. None of these
Answer : B

2. When heat is transferred from hot body to cold body, in a straight line, without affecting the intervening medium, it is referred as heat transfer by
A. Conduction
B. Convection
C. Radiation
D. Conduction and convection
Answer : C

3. Thermal conductivity of water ________ with rise in temperature.
A. Remain same
B. Decreases
C. Increases
D. May increase or decrease depending upon temperature
Answer : D

4. The ratio of Nusselt number and the product of Reynold's number and Prandtl number is equal to
A. Stanton number
B. Biot number
C. Peclet number
D. Grashoff number
Answer : A

5. Heat flows from one body to other when they have
A. Different heat contents
B. Different specific heat
C. Different atomic structure
D. Different temperatures
Answer : D

6. In free convection heat transfer transition from laminar to turbulent flow is governed by the critical value of the
A. Reynold's number
B. Grashoff's number
C. Reynold's number, Grashoff's number
D. Prandtl number, Grashoff's number
Answer : D

7. The total radiation from a black body per second per unit area is ________ fourth power of the absolute temperature. This statement is known as Stefan Boltzmann law.
A. Equal to
B. Directly proportional to
C. Inversely proportional to
D. None of these
Answer : B

8. When absorptivity (?) = 1, reflectivity (?) = 0 and transmissivity (?) = 0, then the body is said to be a
A. Black body
B. Grey body
C. Opaque body
D. White body
Answer : A

9. Heat conducted through per unit area and unit thick face per unit time when temperature difference between opposite faces is unity, is called
A. Thermal resistance
B. Thermal coefficient
C. Temperature gradient
D. Thermal conductivity
Answer : D

10. Reynolds number (RN) is given by (where h = Film coefficient, l = Linear dimension, V = Velocity of fluid, k = Thermal conductivity, t = Temperature, ? = Density of fluid, cp = Specific heat at constant pressure, and ? = Coefficient of absolute viscosity)
A. RN = hl/k
B. RN = ? cp/k
C. RN = ? V l /?
D. RN = V²/t.cp
Answer : C

11. A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h?, h? and h? respectively. The average heat transfer coefficient for the cube is
A. h? + h? + h?
B. (h?.h?.h?)1/3
C. 1/h? + 1/h? + 1/h?
D. None of these
Answer : D

12. According of Kirchhoff's law
A. Radiant heat is proportional to fourth power of absolute temperature
B. Emissive power depends on temperature
C. Emissive power and absorptivity are constant for all bodies
D. Ratio of emissive power to absorptive power for all bodies is same and is equal to the emissive power of a perfectly black body.
Answer : D

13. Thermal conductivity of air at room temperature in kcal/m hr °C is of the order of
A. 0.002
B. 0.02
C. 0.01
D. 0.1
Answer : B

14. Thermal conductivity of water in general with rise in temperature
A. Increases
B. Decreases
C. Remain constant
D. May increase or decrease depending on temperature
Answer : D

15. The highest thermal diffusivity is of
A. Iron
B. Lead
C. Concrete
D. Wood
Answer : B

16. According to Kirchoff's law, the ratio of emissive power to absorptivity for all bodies is equal to the emissive power of a
A. Grey body
B. Brilliant white polished body
C. Red hot body
D. Black body
Answer : D

17. The energy distribution of an ideal reflector at higher temperatures is largely in the range of
A. Shorter wavelength
B. Longer wavelength
C. Remain same at all wavelengths
D. Wavelength has nothing to do with it
Answer : A

18. The process of heat transfer from one particle of the body to another is called conduction, when the particles of the body
A. Move actually
B. Do not move actually
C. Affect the intervening medium
D. Does not affect the intervening medium
Answer : B

19. Which of the following would lead to a reduction in thermal resistance?
A. In conduction, reduction in the thickness of the material and an increase in thermal conductivity.
B. In convection, stirring of the fluid and cleaning the heating surface.
C. In radiation, increasing the temperature and reducing the emissivity.
D. All of the above
Answer : D

20. All radiations in a black body are
A. Reflected
B. Refracted
C. Transmitted
D. Absorbed
Answer : D

21. The ratio of the thickness of thermal boundary layer to the thickness of hydrodynamic boundary layer is equal to (Prandtl number) n, where n is equal to
A. -1/3
B. -2/3
C. 1
D. -1
Answer : A

22. Joule sec is the unit of
A. Universal gas constant
B. Kinematic viscosity
C. Thermal conductivity
D. Planck's constant
Answer : D

23. Log mean temperature difference in case of counter flow compared to parallel flow will be
A. Same
B. More
C. Less
D. Depends on other factors
Answer : B

24. Depending on the radiating properties, a body will be white when
A. P = 0, x = 0 and a = 1
B. P=1, T = 0 and a = 0
C. P = 0, x = 1 and a = 0
D. X = 0, a + p = 1 Where a = absorptivity, p = reflectivity, x = transmissivity
Answer : B

25. Thermal conductivity of wood depends on
A. Moisture
B. Density
C. Temperature
D. All of the above
Answer : D

26. Which of the following has least value of conductivity?
A. Glass
B. Water
C. Plastic
D. Air
Answer : D

27. The emissivity for a black body is
A. 0
B. 0.5
C. 0.75
D. 1
Answer : D

28. Heat is transferred by all three modes of transfer, viz. conduction, convection and radiation in
A. Electric heater
B. Steam condenser
C. Boiler
D. Refrigerator condenser coils
Answer : C

29. 40% of incident radiant energy on the surface of a thermally transparent body is reflected back. If the transmissivity of the body be 0.15, then the emissivity of surface is
A. 0.45
B. 0.55
C. 0.40
D. 0.75
Answer : A

30. In free convection heat transfer, Nusselt number is function of
A. Grashoff number and Reynold number
B. Grashoff number and Prandtl number
C. Prandtl number and Reynold number
D. Grashoff number, Prandtl number and Reynold number
Answer : B

31. Which of the following statement is wrong?
A. The heat transfer in liquid and gases takes place according to convection.
B. The amount of heat flow through a body is dependent upon the material of the body.
C. The thermal conductivity of solid metals increases with rise in temperature
D. Logarithmic mean temperature difference is not equal to the arithmetic mean temperature difference.
Answer : C

32. The thermal diffusivities for solids are generally
A. Less than those for gases
B. Less than those for liquids
C. More than those for liquids and gases
D. More or less same as for liquids and gases
Answer : C

33. The amount of radiation mainly depends on
A. Nature of body
B. Temperature of body
C. Type of surface of body
D. All of the above
Answer : D

34. The most commonly used method for the design of duct size is the
A. Velocity reduction method
B. Equal friction method
C. Static regains method
D. Dual or double method
Answer : C

35. In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by
A. Convection
B. Radiation
C. Conduction
D. Both convection and conduction
Answer : C

36. Sensible heat is the heat required to
A. Change vapour into liquid
B. Change liquid into vapour
C. Increase the temperature of a liquid of vapour
D. Convert water into steam and superheat it
Answer : C

37. The ratio of the emissive power and absorptive power of all bodies is the same and is equal to the emissive power of a perfectly black body. This statement is known as
A. Kirchoffs law
B. Stefan's law
C. Wien' law
D. Planck's law
Answer : A

38. Fourier's law of heat conduction gives the heat flow for
A. Irregular surfaces
B. Nonuniform temperature surfaces
C. One dimensional cases only
D. Two dimensional cases only
Answer : C

39. Fourier's law of heat conduction is valid for
A. One dimensional cases only
B. Two dimensional cases only
C. Three dimensional cases only
D. Regular surfaces having non-uniform temperature gradients
Answer : A

40. The heat transfer from a hot body to a cold body is directly proportional to the surface area and difference of temperatures between the two bodies. This statement is called
A. First law of thermodynamics
B. Newton's law of cooling
C. Newton's law of heating
D. Stefan's law
Answer : B

41. Fouling factor is used
A. In heat exchanger design as a safety factor
B. In case of Newtonian fluids
C. When a liquid exchanges heat with a gas
D. None of the above
Answer : A

42. When ? is absorptivity, ? is reflectivity and ? is tranmissivity, then for a diathermanous body,
A. ? = 1, ? = 0 and ? = 0
B. ? = 0, ? = 1 and ? = 0
C. ? = 0, ? = 0 and ? = 1
D. ? + ? = 1 and ? = 0
Answer : D

43. Unit of thermal conductivity in S.I. units is
A. J/m² sec
B. J/m °K sec
C. W/m °K
D. Option (B) and (C) above
Answer : D

44. The rate of energy transferred by convection to that by conduction is called
A. Stanton number
B. Nusselt number
C. Biot number
D. Peclet number
Answer : B

45. According to Newton's law of cooling, the heat transfer from a hot body to a cold body is
A. Directly proportional to the surface area
B. Directly proportional to the difference of temperatures between the two bodies
C. Either (A) or (B)
D. Both (A) and (B)
Answer : D

46. Which of the following has maximum value of thermal conductivity?
A. Aluminium
B. Steel
C. Brass
D. Copper
Answer : A

47. Heat transfer in liquid and gases takes place by
A. Conduction
B. Convection
C. Radiation
D. Conduction and convection
Answer : B

48. The automobile radiator is a heat exchanger of
A. Parallel flow type
B. Counter flow type
C. Cross flow type
D. Regenerator type
Answer : C

49. A composite slab has two layers of different materials with thermal conductivities k? and k?. If each layer has the same thickness, then the equivalent thermal conductivity of the slab will be
A. k? k?
B. (k? + k?)
C. (k? + k?)/ k? k?
D. 2 k? k?/ (k? + k?)
Answer : D

50. The ratio of the energy absorbed by the body to total energy falling on it is called
A. Absorptive power
B. Emissive power
C. Absorptivity
D. Emissivity
Answer : A