The average crushing strength of hand moulded bricks is 6000 t/m2
The average tensile strength of hand moulded brick is 200 t/m2
The average shearing strength of hand moulded brick is 600 t/m2
All the above
D. All the above
Contain hydrated lime
Contain 5% to 10% colour pigments
Contain 5% sodium chloride
All the above
Drier
Solvent
Resin
All the above
Cracking and warping of bricks
Loss of cohesion
Enhancing the impermeability of bricks
None of the above
Over-burnt bricks
Under-burnt bricks
Refractory bricks
First class bricks
Catalysts are added to assist and accelerate the hardening of resin
The fillers are inert materials and they impart strength and hardness
Fibrous fillers increase thermal resistance
All the above
30 minutes
1 hour
6 hours
10 hours
Clamp
Bull's kiln
Hoffman's kiln
None of these
Styrene resin is produced from ethylene which is made from petroleum
Styrene resin is light in weight
Styrene resin transmits ultraviolet waves of light
All the above
Log
Batten
Plank
Baulk
Hornblende mineral is brittle
Muscovite is also known as white mica and potash mica
Biotite is also known as black-mica
All the above
Slaked lime contains calcium hydroxide
Quick lime contains calcium oxide
Slaked lime may be obtained from quick lime
All the above
190 mm × 90 mm × 80 mm
190 mm × 190 mm × 90 mm
200 mm × 100 mm × 100 mm
200 mm × 200 mm × 100 mm
Radius of its stem
Circumference of its stem
Number of branches
Number of annual rings
Testing of stones
Quarrying of stones
Dressing of stones
None of the above
Clay, lime stone is used as flux
Lime stone, clay is used as flux
Quartz, lime stone and argillaceous iron ores are used as flux
All the above
The monsoon
The winter
The summer
None of these
Dressing
Calcination and roasting
Smelting
All the above
Plastic paints
Cellulose paints
Emulsion paints
Oil paints
It forms octagonal crystals
It converts to chlorine by hydration
Its density is 2.3 to 3.6 g/cm2
All the above
Soft stones are required for carving
Light stones are required for arches
Hard stones are required to stand high pressure
All the above
Tremolite asbestos
Chrysotile asbestos
Amosite asbestos
None of these
Adding 5% to 6% of moisture content by weight, increases the volume of dry sand from 18% to 38%
The bulking of fine sand is more than that of coarse sand
If the percentage content of moisture exceeds 10%, increase in bulk of sand starts increasing
All the above
Lime and silica
Lime and alumina
Silica and alumina
Lime and iron
Air bubbles in casting produce a dull sound by tapping their surfaces lightly with a hammer
Cupola furnace is used for the manufacture of cast iron
Red short iron is of no value for welding purpose
All the above
Generates heat when added to water
Reacts with carbon dioxide
May be used for white-washing
All the above
Homogeneous
Non-homogeneous
Monomineralic
Polymineralic
Cracking of bricks
Shrinkage of bricks
Warping of bricks
None of these
Impermeable
Brittle and weak
To lose cohesion
To crack and warp on drying
Strength
Rigidity
Elasticity
All of these
Powdered silica
Gypsum
Talc
Zinc white