1000+ Airport Engineering MCQ for RBI Assistant [Solved]

1. The landing and takeoff of the air craft is made against the direction of wind. In no case the centre line of the runway should make an angle with the wind direction exceeding
A. 10°
B. 20°
C. 30°
D. 40°
Answer : C

2. Pick up the component not applicable to aeroplanes
A. Wings
B. Engines
C. Air screw
D. None of these
Answer : D

3. For night landing, the thresholds are lighted
A. Green
B. Red
C. White
D. Yellow
Answer : A

4. Runway threshold is indicated by a series of parallel lines starting from a distance of
A. 3 m from runway end
B. 6 m from runway end
C. 10 m from runway end
D. 15 m from runway end
Answer : B

5. The runway orientation is made so that landing and takeoff are
A. Against the wind direction
B. Along the wind direction
C. Perpendicular to wind direction
D. None of these
Answer : A

6. Which of the following is an example of failure in flexible pavements?
A. Alligator cracking
B. Mud pumping
C. Warping cracks
D. Shrinkage cracks
Answer : A

7. The coordinates of the ends of a runway are (5000, 5000) and (8000, 7000). The co-ordinates of another runway are (4600, 5100) and (7000, 5300). The co-ordinates of the A.R.P. are
A. (6500, 6000)
B. (5800, 5200)
C. (61500, 5600)
D. (8000, 7000)
Answer : C

8. The best direction of a runway is along the direction of
A. Longest line on wind rose diagram
B. Shortest line on the wind rose diagram
C. Line clear of wind rose diagram
D. None of these
Answer : A

9. For the proposed air port, the survey project provides
A. Master plan
B. Topographic plan
C. Grading plan
D. All the above
Answer : D

10. If the width of the approach area near the runway end is 150 m, the width of the approach area at a distance of 3 kilometres from runway end will be
A. 1500 m
B. 1200 m
C. 1000 m
D. 800 m
Answer : B

11. Pick up the correct statement from the following:
A. Air screw converts the energy given by the engine into speed
B. The propellers which are driven by turbine engines, are technically called turboprops
C. The aircrafts which obtain the thrust directly from turbine engine, are called turbo-jets
D. All the above
Answer : D

12. The air is blowing at a speed of 75 knots in the direction of the aircraft flying at a ground speed of 775 knots. The air speed of the aircraft, is
A. 775 knots
B. 75 knots
C. 850 knots
D. 675 knots
Answer : D

13. Pick up the correct statement from the following:
A. Runway edge from the landing side, is called threshold
B. Localizer indicates to the pilot his position with respect to the proposed alignment
C. The glide slope indicates the correct angle of descent
D. All the above
Answer : D

14. As per ICAO, for airports serving big aircrafts, the crosswind component should not exceed
A. 15 kmph
B. 25 kmph
C. 35 kmph
D. 45 kmph
Answer : C

15. Pick up the correct statement from the following:
A. Approximate geometric centre of the landing area, is called air port reference point
B. The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
C. The location of the air port on a map is the position of air port reference point
D. All the above
Answer : D

16. The fuse large includes
A. Passengers chamber
B. Pilot's cabin
C. Tail of aircraft
D. All the above
Answer : D

17. Pick up the correct statement from the following:
A. The basic length of a runway is increased at a rate of 7% per 300 m of elevation of M.S.L.
B. The standard temperature at the site is obtained by reducing the standard sea level temperature of 15°C at the rate of 6.5°C per 1000 m rise in elevation
C. The aerodrome reference temperature is the monthly mean of the mean daily temperature for the hottest month of the year
D. All the above
Answer : D

18. If the monthly mean of average daily temperature for the hottest month of the year is 25°C and the monthly mean of the maximum daily temperature of the same month of the year is 46°C, the airport reference temperature is
A. 32°C
B. 35.5°C
C. 48°C
D. 25°C
Answer : C

19. For the taxiways, the following statement is true
A. The maximum longitudinal grade is 3%
B. The permissible rate of change of grade is 1%
C. The permissible transverse grade is 1.5%
D. All the above
Answer : D

20. The height of the pilot's eye above the runway surface is assumed
A. 1 m
B. 3 m
C. 4 m
D. 5 m
Answer : B

21. The maximum length and pavement strength of the runway is that of
A. A 1
B. B 2
C. B 3
D. G 7
Answer : A

22. In Intrumental landing system, the middle markers are located
A. Along the extended centre line of runway end
B. About 1 km. ahead of the runway threshold
C. At the runway threshold
D. About 7 km. ahead of the runway threshold
Answer : B

23. The reduced level of the proposed site of an air port is 2500 m above M.S.L. If the recommended length by I.C.A.O. for the runway at sea level is 2500 m, the required length of the runway is
A. 2500 m
B. 3725 m
C. 3000 m
D. 3250 m
Answer : B

24. Consider the following statements regarding ICAO recommendation for correction to basic runway length
1. The basic runway length should be increased at the rate of 7 percent per 300 m rise in elevation above the mean sea level.
2. The basic runway length after having been corrected for elevation should be further increased at the rate of 1 percent for every 1°C rise in airport reference temperature above the standard atmospheric temperature at that elevation.
3. The runway length after having been corrected for elevation and temperature should be further increased at the rate of 20% for every 1 percent of effective gradient. Of these statements
A. 1 and 2 are correct
B. 2 and 3 are correct
C. 1 and 3 are correct
D. 1, 2 and 3 are correct
Answer : A

25. As per ICAO, for A, B, and C type of airports, maximum effective, transverse and longitudinal grades in percentage respectively are
A. 1.0, 1.5 and 1.5
B. 1.0, 1.5 and 2.0
C. 1.5, 1.5 and 2.0
D. 2.0, 2.0 and 2.0
Answer : A

26. The width and interval of transverse centre line bars along the extended centre line of runway, in approach lighting system are
A. 3 m and 30 m
B. 4.2 m and 30 m
C. 4.2 m and 50 m
D. 3 m and 45 m
Answer : B

27. To cope up high temperature of 196°C, the taxi ways and aprons are constructed with
A. Asphaltic concrete
B. Rubberised tar concrete
C. Plain concrete
D. All the above
Answer : D

28. Maximum gross takeoff weight of an aircraft is
A. Equal to the maximum structural landing weight
B. Less than the maximum structural landing weight
C. More than the maximum structural landing weight
D. Equal to the empty operating weight plus the payload
Answer : C

29. Two single runways may be arranged so as to have
A. L-shape
B. T-shape
C. X-shape
D. All the above
Answer : D

30. Wing loading of an aircraft is
A. Load of the wings
B. Gross total weight of the aircraft/ load of the wings
C. Gross total weight of the aircraft/ wing area
D. Gross total weight of the aircraft/total available H.P of engines
Answer : C

31. According to the International Civil Aviation Organisation (I.C.A.O.), the runway lengths of aerodromes, have been coded by
A. Seven English alphabets
B. Last Seven English alphabets
C. First Seven English alphabets
D. First seven natural numbers
Answer : C

32. Effective length of a runway is the distance between
A. Ends of the runway
B. Point of intersection of the obstruction clearance line and the extended plane of the runway surface, and the other end of the runway
C. Point of intersection of the glide path and the extended plane of the runway surface and the other end of the runway
D. Ends of the clear way on either side
Answer : B

33. From the end of an instrumental runway, the approach surface rises outwards
A. 1 in 20
B. 1 in 30
C. 1 in 40
D. 1 in 50
Answer : D

34. Zero fuel weight of an aircraft is:
A. Equal to empty operating weight
B. Equal to maximum landing weight
C. Less than empty operating weight
D. Equal to sum of empty operating weight and the maximum pay load
Answer : D

35. The engine failure case for determining the basic runway length may require
A. Only clearway
B. Only stop way
C. Either a clearway or a stop-way
D. Either a clearway or a stop-way or both
Answer : D

36. As per ICAO recommendation, minimum width of safety area for instrumental runway should be
A. 78 m
B. 150 m
C. 300 m
D. 450 m
Answer : C

37. Conical surface of the approach area rises outwards
A. 1 in 10
B. 1 in 15
C. 1 in 20
D. 1 in 25
Answer : C

38. As per UK design criteria, if LCN of aircraft is between 1.25 to 1.5 times the LCN of pavement, then the number of movements allowed are
A. Zero
B. 300
C. 3000
D. Unrestricted
Answer : B

39. The total length of a runway is 1000 m. The elevation at distance 0,200 m, 400 m, 600 m, 800 m and 1000 m are 100.0 m, 99.2 m, 101.0 m, 101.8 m, 101.4 m and 101.0 m respectively. The effective gradient of runway will be.
A. 0.10 %
B. 0.26 %
C. 0.43 %
D. 0.65 %
Answer : B

40. Pick up the correct statement from the following:
A. Landing speed is directly proportional to the wing loading
B. Wing loading remaining constant, the take off distance is directly proportional to the powder loading
C. Neither (a) nor (b)
D. Both (a) and (b)
Answer : D

41. In an airport, if 4 groups of 5 gates each located well separated are considered for traffic and the future to present traffic ratio is 3, then the total requirement of future gates will be
A. 32
B. 36
C. 44
D. 68
Answer : B

42. For determining the basic runway length, the landing case requires that aircraft should come to a stop within p % of the landing distance. The value of p is
A. 40 %
B. 50 %
C. 60 %
D. 75 %
Answer : C

43. The runway length after correcting for elevation and temperature is 2845 m. If the effective gradient on runway is 0.5 percent then the revised runway length will be
A. 2845 m
B. 2910 m
C. 3030 m
D. 3130 m
Answer : C

44. The depressions and undulations in the pavement, are caused due to
A. Improper compaction of sub-grade
B. Impact of heavy wheel loads
C. Punching effect
D. All the above
Answer : D

45. The minimum width of clearway is
A. 50 m
B. 100 m
C. 150 m
D. 250 m
Answer : C

46. Pick up the correct statement from the following:
A. Tar concrete pavements are suitable if fuel spillage occurs
B. Rubberised tar concrete hot blast as well as spillage
C. Epoxy asphalt concrete sets in very small time
D. All the above
Answer : D

47. The capacity of parallel runway pattern depends upon
A. Weather conditions and navigational aids available
B. Lateral spacing between two runways and weather conditions
C. Lateral spacing between two runways and navigational aids available
D. Lateral spacing between two runways, weather conditions and navigational aids available.
Answer : D

48. The centre to centre spacing of heliport lighting along the periphery of landing and takeoff area should be
A. 2.5 m
B. 5.0 m
C. 7.5 m
D. 10.0 m
Answer : C

49. Beaufort scale is used to determine
A. Strength of winds
B. Direction of winds
C. Height of air-crafts
D. None of these
Answer : A

50. The strength of winds is measured with the help of
A. Beaufort scale
B. Wind indicator
C. Barometers
D. None of these
Answer : A