The symbol Q refers to
Resonance quotient
Quality factor
Power quotient
Qualification test
Correct Answer :
B. Quality factor
Related Questions
In adding or subtracting phasor quantitiesa ___ form is the most convenient.
Polar
Rectangular
Trigonometric
Exponential
An intermittent and non-symmetrical alternating current like that obtained from the secondary winding of an induction coil
Faradic current
Transient ac current
Inductive current
Capacitive current
Kirchhoff�s laws (KCL and KVL) are applicable to
DCcircuits
ACcircuits
DC as well as AC circuits
Passive networks alone
Which of the following is the most popular waveform?
Sinusoidal
Square wave
Triangular
Sawtooth
What is the value of a carbon composition resistor with the following color code: Browna whitea orangea red
190 ; 10 %
19 k ; 2 %
19 k ; 20 %
1.9 k ; 2 %
What rating of a resistor determines its ability to absorb heat?
Wattage
Ohmic
Current
Voltage
Which of the following is a common material used in wire-wound resistors?
Manganin
Carbon
Bronze
German silver wire
Which of the following conditions is not true for a series RLCcircuit at resonance?
Z = jXL
XL= XC
The power factor is one
The magnitude of Z is
For series capacitorsa total charge is
The sum of individual charges
Equal to the charge of either capacitors
Equal to the product of the charges
The quotient of the charges
If an emf in circuit A produces a current in circuit Ba then the same emf in circuit Bproduces the same current in circuit ? this theorem is known as
Maximum power transfer theorem
Millman�s theorem
Reciprocity theorem
Norton�s theorem
A tank circuit is a
Parallel LC circuit
Series LCcircuit
A resonant circuit
A non-resonant circuit
What is the other name of relative permittivity?
Dielectric strength
Potential gradient
Breakdown voltage
Specific inductance capacity
An inductance of 1 mH is
0.001 H
0.01 H
0.0001 H
0.10 H
A resistor wound with a wire doubled back on itself to reduce the inductance.
Bifilar resistor
Wire-wound resistor
Anti-inductive resistor
Bleeder resistor
In Norton�s theorema the short circuit current is obtained by
Opening the load terminals
Shorting the load terminals
Opening the voltage source
Shorting the voltage source
According to Gauss theorema flux can be equated to
Charge
Field intensity
Current
Voltage
What is the total effective capacitance of two 0.25 F capacitors connected in series?
0.125 F
1.25 F
0.50 F
2.5 if
Which of the following dielectric materials makes the lowest-capacitance capacitor?
Paper
Mica
Air
Electrolyte
If voltage across the plates of 2 F capacitor is increased by 4 Va then charge on the plates will
Decrease by 2 C
Increase by 2 C
Decrease by 4 C
Increase by 4C
What capacitance exists not through design but simply because two conducting surfaces are relatively close to each other?
Surge
Stray
Natural
Normal
When the movable plates of a gang capacitor completely overlap the fixed platesa the capacitance of the capacitor is
Halfway between maximum and minimum
Maximum
Minimum
Zero
In an ac circuit with a resistive branch and an inductive branch in parallela the
Voltage across the inductance leads the voltage across the resistance by 90°
Resistive branch current is 90° out of phase with the inductive branch current
Resistive and inductive branch currents have the same phase
Resistive and inductive branch currents are 180° outof-phase
The Q-factor of a series resonant circuit is also known as
Current magnification factor
Voltage magnification factor
Load factor
Leakage factor
If a coil has a Q of 10a it means that
The energy stored in the magnetic field of the coil is 10 times the energy wasted in its resistance
The energy wasted in its resistance is 10 times the energy stored in the magnetic field of the coil
It is a low Q coil
It is a high Q coil
Which of the following is not a factor affecting dielectric strength?
Mass
Moisture content
Temperature
Thickness
Transient period is considered over after
The second strip of an electronic resistor color-code represents
The multiplier
The second digit of the value
The temperature
The tolerance
The power factor of a circuit is equal to
RZ
XC/Z
XL/Z
R/Z
What refers to the lowest voltage across any insulator that can cause current flow?
Conduction voltage
Critical voltage
Breakdown voltage
Voltage capacity
If three 100-pF capacitors are connected in seriesa then the total capacitance is
300 pF
100 pF
50 pF
33.3 pF