30°
45°
50°
60°
D. 60°
Towards right
Towards left
Alternately towards right and left and every third or fourth left straight
May be bent in any direction
Drawing
Extrusion
Rolling
Extrusion and rolling
Is a two man saw
Is used for cutting along the grains of wood
Has a narrow blade with two wooden handles
All of the above
0.035 mm
0.025 mm
0.01 mm
0.06 mm
Small
Large
Very large
Not provided
Cutting a sheet of metal in a straight line along the length
Removal of metal to the desired shape from the edge of a plate
Cutting a sheet of metal through part of its length and then bending the cut portion
Bending a sheet of metal along a curved axis
5 cm × 5 cm
10 cm × 10 cm
15 cm × 15 cm
20 cm × 20 cm
Zinc diffusion process
Process of coating zinc by hot dipping
Process used for making thin phosphate coating on steel
None of the above
10 mm/m
16 mm/m
20 mm/m
26 mm/m
±0.05 mm
+0.2 mm
+05 mm
+1 mm
Die casting method
Slush casting method
Permanent mould casting method
Centrifugal casting method
Wire drawing
Tube drawing
Metal cutting
Forging
Actual deviation
Upper deviation
Lower deviation
Fundamental deviation
The mortise gauge has two scribing pins
The gouges are chisels with a hollow shaped blade
An auger is a planing tool
All of these
d
1.5d
3d
6d
Cold shuts
Blow holes
Shift
Swell
Black colour
White colour
Maroon colour
Yellow colour
Porosity of the metal is largely eliminated
Grain structure of the metal is refined
Mechanical properties are improved due to refinement of grains
All of the above
Basic size is 100 mm
Actual size is 100 mm
Difference between the actual size and basic size is 100 mm
None of the above
5 litres
10 litres
15 litres
20 litres
Ferrous alloys with low melting temperature are casted
Ferrous alloys with high melting temperature are casted
Nonferrous alloys with low melting temperature are casted
Nonferrous alloys with high melting temperature are casted
+0.05 mm
±0.2 mm
+0.5 mm
±1 mm
Poor surface finish is produced
Scale is formed on the metal surface
Close tolerances cannot be maintained
All of these
Mild steel
Brass
Copper
Aluminium
Galvanising
Anodising
Parkerising
Sherardizing
Voltage
Flow of current
Contact resistance
All of these
Helium gas
Argon gas
Either (A) or (B)
None of these
Flat chisel
Cape chisel
Round nose chisel
Diamond pointed chisel
Shift
Sand wash
Swell
Scab
It is not possible to reduce at one stage
Annealing is needed between stages
Accuracy in dimensions is not possible otherwise
Surface finish improves after every drawing stage