Home

Points to be considered in choosing a capacitor

A. Working voltage

B. Type of dielectric

C. Capacitance

D. All of the above

Related Questions

  1. The ratio between the reactive power and the apparent power of an ac load is called
  2. As applied to a series RLCcircuita bandwidth means
  3. What is the form factor of a triangular wave?
  4. The Q-factor of a parallel resonant circuit is also known as
  5. For a series circuita the higher the quality factor
  6. If a coil has a Q of 10a it means that
  7. Which one of the following elements serves as a protection against overload?
  8. What is the total capacitance of 10 capacitorsa each of 20 F in series?
  9. What determines the magnitude of electric current?
  10. If the output resistance of a voltage source is 4 a it internal resistance should be
  11. A law which states that when a constant electromotive force is applied to a circuit consisting of a…
  12. For a triangular and sawtooth waveform the rms voltage or current equals
  13. What theorem is generally used in the analysis of vacuum tubes?
  14. For parallel capacitorsa total charge is
  15. A capacitive load always has a ______ power facto
  16. A capacitor requires 12 C of charge to raise its potential of 3 V. What is the capacitance of the capacitor?
  17. The wavelength of an alternating waveform depends upon the ___ of the variation.
  18. A capacitance of 6 F means
  19. What is considered as the most important value of a sine wave?
  20. Barium-strontium titanite dielectric material is also called
  21. If three 100-pF capacitors are connected in seriesa then the total capacitance is
  22. Parallel resonant circuit is sometimes called as
  23. The capacitor opposes any change in voltage across it by
  24. Of the equivalent combination of unitsa which one is not equal to watt?
  25. What is the cross-sectional are of a conductor whose diameter is 0.001 inch?
  26. The factor 0.707for converting peak to rms applies only to
  27. Resistor with colored bands in the body
  28. Loop currents should be assumed to flow in which direction
  29. In a resonant circuita if Q ? 10 resonant frequency _______ bandwidth.
  30. The Q-factor of a series resonant circuit is also known as

Please do not use chat terms. Example: avoid using "grt" instead of "great".