The C.G. of the shaded area of the below figure from the x-axis is 
a/4
3a/4
3b/10
3a/10
Correct Answer :
C. 3b/10
Related Questions
The maximum velocity of a body vibrating with a simple harmonic motion of amplitude 150 mm and frequency 2 vibrations/sec, is
188.5 m/sec
18.85 m/sec
1.885 m/sec
0.18845 m/sec
The velocity of a moving body, is
A vector quantity
A scalar quantity
A constant quantity
None of these
A load of 500 kg was lifted through a distance of 13 cm. by an effort of 25 kg which moved through a distance of 650 cm. The velocity ratio of the lifting machine is
50
55
60
65
The angular speed of a car while taking a circular turn of radius 100 m at 36 km/hour, is
0.1 radian/sec
1 radian/sec
100 radian/sec
1000 radian/sec
Cartesian form of the equation of catenary is
y = c cosh x/c
y = c sinh x/c
y = c tan x/c
y = c sin x/c
A ball of mass 250 g moving on a smooth horizontal table with a velocity of 10 m/sec hits an identical stationary ball B on the table. If the impact is perfectly plastic, the velocity of the ball B just after impact would be
Zero
5 m/sec
10 m/sec
None of these
A projectile is fired at an angle θ to the vertical. Its horizontal range will be maximum when θ is
0°
30°
45°
90°
Maximum efficiency of a screw jack for the angle of friction θ, is
sin θ/(1 + sin θ)
(1 - sin θ)/sin θ
(1 + sin θ)/(1 - sin θ)
(1 - sin θ)/(1 + sin θ)
If a particle is projected inside a horizontal tunnel which is 554 cm high with a velocity of 60 m per sec, the angle of projection for maximum range, is
8°
9°
10°
11°
The resultant of two forces P and Q is R. If Q is doubled, the new resultant is perpendicular to P. Then,
P = R
Q = R
P = Q
None of the above is correct
On a ladder resting on a rough ground and leaning against a smooth vertical wall, the force of friction acts
Downwards at its upper end
Upwards at its upper end
Perpendicular to the wall at its upper end
Zero at its upper end
A force P of 50 N and another force Q of unknown magnitude act at 90° to each other. They are balanced by a force of 130 N. The magnitude of Q is
60 N
80 N
100 N
120 N
If two forces P and Q (P > Q) act on the same straight line but in opposite direction, their resultant, is
P + Q
P/Q
Q/P
P - Q
Pick up the incorrect statement from the following. In a simple harmonic motion
Velocity is maximum at its mean position
Velocity is minimum at the end of the stroke
Acceleration is minimum at the end of the stroke
Acceleration is zero at the mean position
A square hole is punched out of a circular lamina, the diagonal of the square being the radius of the circle. If r is the radius of the circle, the C.G. of the remainder from the corner of the square on the circumference will be
[r (π + 0.25)]/(π - 0.5)
[r (π - 0.5)]/(π + 0.25)
[r (π - 0.25)]/(π - 0.5)
[r (π + 0.25)]/(π + 0.5)
Centre of gravity of a thin hollow cone lies on the axis of symmetry at a height of
One-half of the total height above base
One-third of the total height above base
One-fourth of the total height above base
None of these
The pole distance is measured in
Distance scale
Force scale
Mass scale
Time scale
A Seconds pendulum executes
0.5 beat per second
1.0 beat per second
2.0 beats per second
2.5 beats per second
To avoid bending action at the base of a pier,
Suspension and anchor cables are kept at the same level
Suspension and anchor cables are fixed to pier top
Suspension cable and anchor cables are attached to a saddle mounted on rollers on top of the pier
None the these
Engineer's units of force, is
Newton in absolute units
Dyne in absolute units
Newton and dyne in absolute units
All the above
A sphere and a cylinder having the same mass and radii start from rest and roll down the same inclined plane. Which body gets to the bottom first?
Sphere with greater rotational energy at bottom than cylinder
Sphere with lesser rotational energy at bottom than cylinder
Cylinder with greater rotational energy at bottom than sphere
Both reach the bottom simultaneously with equal rotational energy at bottom
If a body moves in such a way that its velocity increases by equal amount in equal intervals of time, it is said to be moving with
A uniform retardation
A uniform acceleration
A variable acceleration
A variable retardation
If the radius of the earth is 600 km the height of a mountain above sea level at the top of which a beat seconds pendulum at sea level, looses 27 seconds a day, is
500 metres
1000 metres
1500 metres
2000 metres
Which one of the following statements is true?
The tangent of the angle of friction is equal to coefficient of friction
The angle of repose is equal to angle of friction
The tangent of the angle of repose is equal to coefficient of friction
All the above
One end of a light string 4 m in length is fixed to a point on a smooth wall and the other end fastened to a point on the surface of a smooth sphere of diameter 2.25 m and of weight 100 kg. The tension in the string is
17.5 kg
19.5 kg
22.5 kg
25 kg
Which of the following represents the state of neutral equilibrium?
A cube resting on one edge
A smooth cylinder lying on a curved surface
A smooth cylinder lying on a convex surface
None of the above
A flywheel of moment of inertia 20 kgm is acted upon by a tangential force of 5 N at 2 m from its axis, for 3 seconds. The increase in angular velocity in radian per second is
1/2
3/2
2
3
The equation of motion of a particle starting from rest along a straight line is x = t3 - 3t2+ 5. The ratio of the accelerations after 5 sec and 3 sec will be
2
3
4
5
A spring scale in a stationary lift shows a reading of 60 kg for a man standing on it. If the lift starts descending at an acceleration of g/5, the scale reading would be
48 kg
60 kg
72 kg
None of these
If two forces are in equilibrium, then the forces must (i) Be equal in magnitude (ii) Be opposite in sense (iii) Act along the same line The correct answer is
(i) and (ii)
(i) and (iii)
Only (i)
All (i), (ii) and (iii)