A load of 500 kg was lifted through a distance of 13 cm. by an effort of 25 kg which moved through a distance of 650 cm. The velocity ratio of the lifting machine is
50
55
60
65
Correct Answer :
A. 50
Related Questions
Minimum potential energy of a system will be in the position of
Stable equilibrium
Unstable equilibrium
Neutral equilibrium
All of the above
A Seconds pendulum executes
0.5 beat per second
1.0 beat per second
2.0 beats per second
2.5 beats per second
The diagram showing the point of application and line of action of forces in their plane is called
Vector diagram
Space diagram
Force diagram
Funicular diagram
The motion of a particle is described by the relation x = t2- 10t + 30, where x is in metres and t in seconds. The total distance travelled by the particle from t = 0 to t = 10 seconds would be
Zero
30 m
50 m
60 m
To attain the synchronous orbit, the launch of a satellite, is done from a place
On equator
On 30° latitude
On 45° latitude
On the poles
Two particles have been projected at angles 64° and 45° to the horizontal. If the velocity of projection of first is 10 m/sec, the velocity of projection of the other for equal horizontal ranges is
9.3 m/sec
8.3 m/sec
7.3 m/sec
6.3 m/sec
A Second's pendulum gains 2 minutes a day. To make it to keep correct time its length
Must be decreased
Must be increased
Is not changed but weight of the bob is increased
Is not changed but weight of the bob is decreased
A heavy ladder resting on a floor and against a vertical wall may not be in equilibrium, if
Floor is smooth and the wall is rough
Floor is rough and the wall is smooth
Floor and wall both are smooth surfaces
Floor and wall both are rough surfaces
The rate of change of displacement of a body with respect to its surrounding, is known
Velocity
Acceleration
Speed
None of these
For lifting a load of 50 kg through a distance of 2.5 cm, an effort of 12.5 kg is moved through a distance of 40 cm. The efficiency of the lifting machine, is
60 %
65 %
70 %
75 %
The pole distance is measured in
Distance scale
Force scale
Mass scale
Time scale
A ball of mass 250 g moving on a smooth horizontal table with a velocity of 10 m/sec hits an identical stationary ball B on the table. If the impact is perfectly plastic, the velocity of the ball B just after impact would be
Zero
5 m/sec
10 m/sec
None of these
A particle moves with a velocity of 2 m/sec in a straight line with a negative acceleration of 0.1 m/sec2. Time required to traverse a distance of 1.5 m, is
40 sec
30 sec
20 sec
15 sec
If the tension in a cable supporting a lift moving upwards is twice the tension when the lift is moving downwards, the acceleration of the lift, is
g/2
g/3
g/4
g/5
The locus of the instantaneous centre of a moving rigid body, is
Straight line
Involute
Centroid
Spiral
A particle is dropped from a height of 3 m on a horizontal floor, which has a coefficient of restitution with the ball of 1/2. The height to which the ball will rebound after striking the floor is
0.5 m
0.75 m
1.0 m
1.5 m
A trolley wire weighs 1 kg per metre length. The ends of the wire are attached to two poles 20 m apart. If the horizontal tension is 1000 kg, the central dip of the cable is
2 cm
3 cm
4 cm
5 cm
The displacement of a particle which moves along a straight line is given by S = 4t3 + 3t2- 10 where S is in meters and t is in seconds. The time taken by the particle to acquire a velocity of 18 m/sec from rest, is
½ sec
1 sec
1.2 sec
1.5 sec
The reaction at the support A of the beam shown in below figure is 
2 t
5.8 t
0.2 t
3.5 t
The centre of gravity of a homogenous body is the point at which the whole
Volume of the body is assumed to be concentrated
Area of the surface of the body is assumed to be concentrated
Weight of the body is assumed to be concentrated
All the above
Free body diagram is an
Isolated joint with only body forces acting on it
Isolated joint with internal forces acting on it
Isolated joint with all the forces, internal as well as external, acting on it
None of the above
A load of 500 kg was lifted through a distance of 13 cm. by an effort of 25 kg which moved through a distance of 650 cm. The velocity ratio of the lifting machine is
50
55
60
65
The C.G. of the shaded area of the below figure from the x-axis is 
a/4
3a/4
3b/10
3a/10
In a simple screw jack, the pitch of the screw is 9 mm and length of the handle operating the screw is 45 cm. The velocity ratio of the system is
1.5
5
25
314
A body of weight 14 g appears to weight 13 g when weighed by a spring balance in a moving lift. The acceleration of the lift at that moment was
0.5 m/sec2
0.7 m/sec2
1 m/sec2
1 cm/sec2
The forces which meet at one point and have their lines of action in different planes are called
Coplanar non-concurrent forces
Non-coplanar concurrent forces
Non-coplanar non-current forces
Intersecting forces
A particle executes a simple harmonic motion. While passing through the mean position, the particle possesses
Maximum kinetic energy and minimum potential energy
Maximum kinetic energy and maximum potential energy
Minimum kinetic energy and maximum potential energy
Minimum kinetic, energy and minimum potential energy
The resolved part of the resultant of two forces inclined at an angle θ in a given direction is
Algebraic sum of the resolved parts of the forces in the direction
Arithmetical sum of the resolved parts of the forces in the direction
Difference of the forces multiplied by cosine θ°
Sum of the forces multiplied by the tangent θ°
In case of S.H.M. the period of oscillation (T), is given by
T = 2ω/π²
T = 2π/ω
T = 2/ω
T = π/2ω
A sphere and a cylinder having the same mass and radii start from rest and roll down the same inclined plane. Which body gets to the bottom first?
Sphere with greater rotational energy at bottom than cylinder
Sphere with lesser rotational energy at bottom than cylinder
Cylinder with greater rotational energy at bottom than sphere
Both reach the bottom simultaneously with equal rotational energy at bottom