Nominal size
Basic size
Actual size
Tolerance
D. Tolerance
Outside micrometer
Inside micrometer
Depth gauge micrometer
Vernier caliper
At the recrystallisation temperature
Below the recrystallisation temperature
Above the recrystallisation temperature
At any temperature
Porosity of the metal is largely eliminated
Grain structure of the metal is refined
Mechanical properties are improved due to refinement of grains
All of the above
Smoothing and cleaning out depressions in the mould
Cleaning the moulding sand
Moistening the sand around the edge before removing pattern
Reinforcement of sand in the top part of the moulding box
Length
Material
Width
Number of teeth
Less than 0.1 percent
Less than 0.3 percent
More than 0.3 percent
Anywhere between 0.1 to 1 percent
Press load is reduced
Good cut edge is obtained
Warping of sheet is minimised
Cut blanks is straight
Zinc diffusion process
Process of coating zinc by hot dipping
Process used for making thin phosphate coating on steel
None of the above
Sand slinger
Squeezing machine
Jolt machine
Stripper plate machine
Light in weight
Easy to work
Corrosion resistant
All of these
d
1.5d
3d
6d
Solid form
Gaseous form
Liquid form
Any one of these
Equal volumes of oxygen and acetylene
More volume of oxygen and less volume of acetylene
More volume of acetylene and less volume of oxygen
None of the above
10 mm/m
16 mm/m
20 mm/m
26 mm/m
TIG welding
MIG welding
Manual arc welding
Submerged arc welding
Galvanising
Anodising
Parkerising
Sherardizing
Drawing
Extrusion
Rolling
Extrusion and rolling
From left to right
From right to left
First from left to right and then from right to left
Either from left to right or from right to left
1 to 2 mm/m
2 to 5 mm/m
5 to 10 mm/m
10 to 15 mm/m
Lower critical temperature
Upper critical temperature
Eutectic temperature
Recrystallisation temperature
Basic size is 100 mm
Actual size is 100 mm
Difference between the actual size and basic size is 100 mm
None of the above
Flat chisel
Cape chisel
Round nose chisel
Diamond pointed chisel
1800°C
2100°C
2400°C
3200°C
Melting pot is separate from the machine
Melting pot is an integral part of the machine
Melting pot may have any location
High temperature and pressure is used
Riser
Sprue
Core
None of these
Compressive stress in the flange
Tensile stress in the wall
Both (A) and (B)
None of these
Mild steel
Brass
Copper
Aluminium
Equal to
Less than
Greater than
None of these
Ram the sand harder at the pattern face with decreasing hardness towards the back of the mould
Ram the sand harder at the back of the mould and softer on the pattern face
Produce uniform packing of sand in the mould
Give uniform sand hardness throughout the mould
Wooden nails
Box nails
Wire nails
None of these