Related Questions
What is the correct answer?
4
Projection welding & stud welding is categorised as the __________ welding.
What is the correct answer?
4
The main constituent of bones is
What is the correct answer?
4
Fine grained steels have
B. Higher tendency to distort
What is the correct answer?
4
Other parameters remaining same, the recrystallisation temperature of an alloy is lowered, when
A. Strain rate is increased
B. Grain size is increased
C. Prior cold deformation is increased
D. Not affected by any of the above parameters
What is the correct answer?
4
Referring to the periodic table of elements, it is found that with increasing atomic number. The atomic size in the same
What is the correct answer?
4
Heat transfer to the water wall in a high pressure water wall type boiler furnace is mainly by
What is the correct answer?
4
Which of the following equipments is used for liquid dispersion?
C. Bubble cap plate column
What is the correct answer?
4
If a nuclear reactor produces more fissile nuclear fuel than it consumes, then it is called a __________ reactor.
What is the correct answer?
4
Thermistors are used in __________ devices.
C. Temperature compensating
What is the correct answer?
4
The yield point phenomenon observed in annealed low carbon steel is due to the presence of the following element.
What is the correct answer?
4
Hooke's law
A. Applies to elastic deformation
B. Applies beyond limit of proportionality in stress-strain curve
C. States that stress is inversely proportional to strain upto elastic limit
What is the correct answer?
4
Atomic __________ of an element is a whole number.
What is the correct answer?
4
Which of the following is not a characteristic observed in material failure by fatigue fracture?
A. Plastic deformation of material does not occur
B. Initiation of crack from below the surface does not occur
C. Initiation of crack occurs on the surface of the machine part
D. Presence of both rough & smooth zone with conchoidal markings in smooth zone of the surface
What is the correct answer?
4
__________ is the hardest oxide and is hence used where high wear resistance at high temperature is required.
What is the correct answer?
4
Non-ferrous alloys used for making cutting tools need not have high
What is the correct answer?
4
Spark plug is provided in a/an
A. Engine having carburettor
C. Compression ignition engine
What is the correct answer?
4
With decrease in the grain size of a material, its creep resistance
D. Either (A) or (B); depends on the material
What is the correct answer?
4
The behaviour of a metal specimen, which when plastically strained in tension reduces its yield stress in compression and vice versa; is termed as the
D. Stress recovery effect
What is the correct answer?
4
Silicon percentage in acid resistant cast iron is about
What is the correct answer?
4
Wave length of X-rays is about 1 angstrom; however it cannot pass through a sheet of
What is the correct answer?
4
X-rays are
D. Of higher wavelength than visible light
What is the correct answer?
4
During sensible cooling of air, its wet bulb temperature
A. Decreases but dew point remains constant
B. Increases but dew point remains constant
C. Increases & the dew point decreases
D. Decreases & the dew point increases
What is the correct answer?
4
__________ of austenite decreases the hardenability in steel.
D. Dissolved elements (except cobalt)
What is the correct answer?
4
Maximum permissible air velocity in pipelines is about __________ metre/second.
What is the correct answer?
4
A common disinfectant used in village wells for disinfection of water is
D. Potassium permanganate
What is the correct answer?
4
The phenomenon occurring during explosion of a hydrogen bomb is
C. A combination of both nuclear fission & fusion
What is the correct answer?
4
Thermal equivalent of electrical power in practical calculation is __________ kcal/kWh.
What is the correct answer?
4
A semi-conductor is damaged & behaves like a conductor, on passing a strong electric current through it, because it heats up the crystals & breaks the covalent bonds resulting in __________ electrons.
What is the correct answer?
4
A particle is settling in a liquid under Stokesian conditions. The free falling velocity of the particle is proportional to
What is the correct answer?
4
Unit of surface tension in S.I. unit is
B. Joule/
C. Newton/