Tool is stationary and work reciprocates
Work is stationary and tool reciprocates
Tool moves over stationary work
Tool moves over reciprocating work
B. Work is stationary and tool reciprocates
Morse taper
Seller's taper
Chapman taper
Brown and Sharpe taper
Continuous chips are formed
Discontinuous chips are formed
Continuous chips with built-up edge are formed
No chips are formed
1 in 10
1 in 15
1 in 20
1 in 30
Cross direction only
Longitudinal direction only
Both cross and longitudinal direction
Any direction
Taper tap
Second tap
Bottoming tap
Any one of these
Watch maker's lathe
Sliding head stock automatic lathe
Multi-spindle automatic lathe
Capstan lathe
Gas tungsten arc welding
Resistance spot welding
Friction welding
Submerged arc welding
Making a cone-shaped enlargement of the end of a hole
Smoothing and squaring the surface around a hole
Sizing and finishing a small diameter hole
Producing a hole by removing metal along the circumference of a hollow cutting tool
Flat type
V-type
Dovetail type
Any one of these
Softer metals
Cotton fabric
Carbon
Graphite
Soft grade
Medium grade
Hard grade
None of these
Of maximum diameter 15 mm
In 15 mm thick plates
Having cross-sectional area of 15 mm²
None of these
Incomplete fusion
Lamellar tearing
Mismatch
Shrinkage void
Profile milling
Gang milling
Saw milling
Helical milling
A to H
I to P
Q to Z
A to P
Lip clearance angle
Helix angle
Point angle
Chisel edge angle
0.1 mm
0.4 mm
0.35
0.75 mm
Circular Interpolation − clockwise
Circular Interpolation − counter clockwise
Linear Interpolation
Rapid feed
15 to 19 m/min
25 to 31 m/min
60 to 90 m/min
90 to 120 m/min
It can not be used on old machines due to backlash between the feed screw of the table and the nut.
The chips are disposed off easily and do not interfere with the cutting.
The surface milled appears to be slightly wavy.
The coolant can be poured directly at the cutting zone where the cutting force is maximum.
Pull broaching
Push broaching
Surface broaching
Continuous broaching
Remain constant
Increases
Decreases
First increases and then decreases
0.1 to 0.2
0.20 to 0.25
0.25 to 0.40
0.40 to 0.55
Above the line joining the two wheel centres
Below the line joining the two wheel centres
On the line joining the two wheel centres
At the intersection of the line joining the wheel centres with the work place plane
5°
10°
15°
20°
Minimum at the beginning of the cut and maximum at the end of the cut
Maximum at the beginning of the cut and minimum at the end of the cut
Uniform throughout the cut
None of these
Tungsten carbide
Brass or copper
Diamond
Stainless steel
Making a cone-shaped enlargement of the end of a hole
Smoothing and squaring the surface around a hole
Sizing and finishing a small diameter hole
Producing a hole by removing metal along the circumference of a hollow cutting tool
Increasing the cutting speed
Decreasing the cutting speed
Increasing the depth of cut
Increasing the feed rate
By a form tool
By setting over the tail stock
By a taper turning attachment
By swivelling the compound rest