Plastics are chemical resistant
Plastics are durable
Plastics are ductile
Plastics are excellent electric insulators
C. Plastics are ductile
In basic Bessemer process, the steel heats the converter
In open-hearth process, the furnace heats the steel
In Siemens process, the impurities of pig iron are oxidised by the oxygen of the ore
All the above
Calcium oxide
Silica
Clay
Water
1570°C
1630°C
1730°C
1850°C
Over-burnt bricks
Under-burnt bricks
Refractory bricks
First class bricks
Lime 63% ; silica 22% ; other ingredients 15%
Lime 22% ; silica 63% ; other ingredients 15%
Silica 40% ; lime 40% ; other ingredients 20%
Silica 70% ; lime 20% ; other ingredients 10%
Keeping it exposed to air
Immersing the lime in water
Crushing the lime lumps
None of these
8% moisture content
10% moisture content
12% moisture content
14% moisture content
Adding 5% to 6% of moisture content by weight, increases the volume of dry sand from 18% to 38%
The bulking of fine sand is more than that of coarse sand
If the percentage content of moisture exceeds 10%, increase in bulk of sand starts increasing
All the above
Becomes rigid when moulded at suitable pressure and temperature
At 127°C to 177°C permanently set and further application of heat does not soften it
Chars at 343°C
All the above
Granite
Dolerite
Basalt
All the above
Bottom face
Top face
Shorter side
Longer side
Is brittle
Warps due to changes in humidity
Strength is lowered when saturated by water
All of the above
Quartz
Mica
Gypsum
None of the above
Acid test is done to find out the weathering quality of stones
Attrition test is done to find out the rate of wear of stones which are used in road construction
Crushing test is done to find out the compressive strength of the stone
All the above
Slate
Plank
Board
Strip
To remove moisture
To remove carbonic acid
By roasting in heaps
All the above
Absence of sun light
Dampness
Presence of sap
All the above
Structural works in beams
Small sized water pipes
Columns and struts
None to these
Alumina
Silica
Iron
Magnesia
25, 75
30, 70
35, 65
All of these
Zinc, lead and nickel
Silver, gold and lead
Copper, nickel and zinc
Copper, brass and zinc
Cambium layer
Annular rings
Medullary rays
Heart wood
Hydraulic lime
Fat lime
Quick lime
Pure lime
1.5% to 5.5%
0.5% to 1.75%
0.1% to 0.25%
None to these
Top face
Bottom face
Longer face
Shorter side
Plastics are chemical resistant
Plastics are durable
Plastics are ductile
Plastics are excellent electric insulators
Strength
Durability
Workability
Water content
Drier
Solvent
Resin
All the above
Increases
Decreases
First increases to a certain maximum value and then decreases
First decreases to a certain minimum value and then increases
The average crushing strength of hand moulded bricks is 6000 t/m2
The average tensile strength of hand moulded brick is 200 t/m2
The average shearing strength of hand moulded brick is 600 t/m2
All the above