Chills and chaplets
Chills and padding
Chaplets and padding
Chills, chaplets and padding
B. Chills and padding
For finishing flat surfaces
For necking down a piece of work
For punching a hole
To finish the punched hole
Clay type binder
Organic type binder
Inorganic type binder
Any one of these
Equal volumes of oxygen and acetylene
More volume of oxygen and less volume of acetylene
More volume of acetylene and less volume of oxygen
None of the above
Simple die
Progressive die
Combination die
Compound die
Is extensively used for making bolts and rivets
Is used for reducing the diameters of round bars and a tube by rotating dies which open and close rapidly on the work
Is used to improve fatigue resistance of the metal by setting up compressive stresses in its surface
Consists of pressing the metal inside a chamber to force it out by high pressure through an orifice which is shaped to provide the desired form of the finished part
10 mm/m
16 mm/m
20 mm/m
26 mm/m
Basic size is 100 mm
Actual size is 100 mm
Difference between the actual size and basic size is 100 mm
None of the above
Rectangular
Square
Hexagonal
Octagonal
Refining grain size
Reducing original block into desired shape
Controlling the direction of flow lines
All of these
Wire drawing
Tube drawing
Metal cutting
Forging
Same
Less
More
None of these
Black colour
White colour
Maroon colour
Yellow colour
Boring
Marking
Cutting
None of these
At the recrystallisation temperature
Below the recrystallisation temperature
Above the recrystallisation temperature
At any temperature
Plunging
Notching
Slitting
Forming
Drawing
Rolling
Piercing
Forging
Galvanising
Anodising
Parkerising
Sherardizing
Sand slinger
Squeezing machine
Jolt machine
Stripper plate machine
Low melting temperature
High melting temperature
Both (A) and (B)
None of these
Sand slinger
Squeezing machine
Jolt machine
Stripper plate machine
Large electrode is used
Welding rod coated with slag is used
Welding rod coated with fluxing material is used
None of the above
Horizontal core
Vertical core
Drop core
Balanced core
Symmetrical shape about vertical axis
Symmetrical shape about horizontal axis
Irregular shape
Nonferrous metal only
One is working roll and three are backing up rolls
Two are working rolls and two are backing up rolls
Three are working rolls and one is backing up roll
All of the four are working rolls
Cross filing
Draw filing
Pull and push filing
None of these
Alternating current with high frequency is used
Alternating current with low frequency is used
Direct current is used
Any one of these
Smoothing and cleaning out depressions in the mould
Cleaning the moulding sand
Moistening the sand around the edge before removing pattern
Reinforcement of sand in the top part of moulding box
Deliver molten metal into the mould cavity
Act as a reservoir for the molten metal
Feed the molten metal to the casting in order to compensate for the shrinkage
Deliver the molten metal from pouring basin to gate
Actual deviation
Upper deviation
Lower deviation
Fundamental deviation
1000°C
1250°C
2100°C
3200°C