Drawing
Rolling
Piercing
Forging
Cold shuts
Blow holes
Shift
Swell
Low melting temperature
High melting temperature
Both (A) and (B)
None of these
Melting pot is separate from the machine
Melting pot is an integral part of the machine
Melting pot may have any location
High temperature and pressure is used
Wooden nails
Box nails
Wire nails
None of these
10 mm/m
16 mm/m
20 mm/m
26 mm/m
Outside micrometer
Inside micrometer
Depth gauge micrometer
Combination set
Towards right
Towards left
Alternately towards right and left and every third or fourth left straight
May be bent in any direction
Rough file
Bastard file
Second cut file
Smooth file
Equal volumes of oxygen and acetylene
More volume of oxygen and less volume of acetylene
More volume of acetylene and less volume of oxygen
None of the above
Drag
Cheek
Cope
None of these
Two or more operations are performed simultaneously at the single stroke of the ram
Two or more cutting operations are performed at one station of the press in every stroke of the ram
Both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram
None of the above
The upper and middle rolls rotate in the same direction whereas the bottom roll rotates in opposite direction
The upper and bottom rolls rotate in the same direction whereas the middle roll rotates in opposite direction
The bottom and middle roll rotate in the same direction
Any one of the above
Striking tool
Planing tool
Boring tool
Marking tool
30°-40°
40°-50°
50°-60°
60°-70°
Galvanising
Anodising
Parkerising
Sherardizing
Ram the sand harder at the pattern face with decreasing hardness towards the back of the mould
Ram the sand harder at the back of the mould and softer on the pattern face
Produce uniform sand hardness throughout the mould
Produce uniform packing of sand in the mould
Feeler gauge
Slip gauge
Ring gauge
Plug gauge
Basic size is 100 mm
Actual size is 100 mm
Difference between the actual size and basic size is 100 mm
None of the above
Nominal size
Basic size
Actual size
Tolerance
Camber on the rolls
Offset on the rolls
Hardening of the rolls
Antifriction bearings
Same
Less
More
None of these
Forward stroke
Return stroke
Both forward and return strokes
Cutting depends upon the direction of force
Single cut file
Double cut file
Rasp cut file
Any one of these
Machining allowance
Draft allowance
Shrinkage allowance
Distortion allowance
Porosity of the metal is largely eliminated
Grain structure of the metal is refined
Mechanical properties are improved due to refinement of grains
All of the above
Direct current with straight polarity is used
Direct current with reversed polarity is used
Alternating current is used
Any one of these
Hot piercing
Extrusion
Cold peening
Cold heading
Ferrous materials
Ductile materials
Hard materials
None of these
Forehand
Backhand
Vertical
None of these