If the radius of wire stretched by a load is doubled, then its Youngs modulus will be

A. Doubled

B. Halved

C. Becomes four times

D. None of the above

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The mass of flue gas per kg of fuel is the ratio of the
  2. Otto cycle consists of following four processes
  3. The intensity of stress which causes unit strain is called
  4. The polytropic index (n) is given by
  5. The columns whose slenderness ratio is less than 80, are known as
  6. A pressure vessel is said to be a thick shell, when
  7. According to Avogadro's law
  8. Workdone during adiabatic expansion is given by (where p1 v1, T1 = Pressure, volume and temperature…
  9. A beam is loaded as cantilever. If the load at the end is increased, the failure will occur
  10. In S. I. units, the value of the universal gas constant is
  11. The layer at the centre of gravity of the beam as shown in the below figure, will be
  12. A boiler shell 200 cm diameter and plate thickness 1.5 cm is subjected to internal pressure of 1.5 MN/m,…
  13. The energy stored in a body when strained within elastic limit is known as
  14. Brayton cycle consists' of following four processes
  15. The value of Poisson's ratio for steel is between
  16. In a uniform bar, supported at one end in position, the maximum stress under self weight of bar shall…
  17. When a body is subjected to a direct tensile stress (σ) in one plane, then maximum normal stress…
  18. A process, in which the gas is heated or expanded in such a way that the product of its pressure and…
  19. The pressure exerted by an ideal gas is ________ of the kinetic energy of all the molecules contained…
  20. The torsional rigidity of a shaft is expressed by the
  21. Carbonisation of coal consists of
  22. The temperature at which the volume of a gas becomes zero is called
  23. In a free expansion process,
  24. The limit of eccentricity for no tensile conditions for a column of circular section of diameter (D)…
  25. The general gas equation is (where p = Pressure, v = Volume, m = mass, T = Absolute temperature, and…
  26. According to Euler's column theory, the crippling load for a column of length (l) with one end fixed…
  27. Which of the following has the highest calorific value?
  28. The principal constituents of a fuel are
  29. For a beam, as shown in the below figure, when the load W is applied in the centre of the beam, the…
  30. Slenderness of a column is zero when