Pick up the correct statement from the following:
Air screw converts the energy given by the engine into speed
The propellers which are driven by turbine engines, are technically called turboprops
The aircrafts which obtain the thrust directly from turbine engine, are called turbo-jets
All the above
Correct Answer :
D. All the above
Related Questions
The main disadvantage of angle nose out parking configuration of aircraft is that the
Aircraft rear loading door is far away from terminal building.
Hot blast is directed towards the terminal building
Overall apron area required is more
All the above
Conical surface of the approach area rises outwards
1 in 10
1 in 15
1 in 20
1 in 25
The best direction of a runway is along the direction of
Longest line on wind rose diagram
Shortest line on the wind rose diagram
Line clear of wind rose diagram
None of these
Pick up the correct statement from the following:
Landing speed is directly proportional to the wing loading
Wing loading remaining constant, the take off distance is directly proportional to the powder loading
Neither (a) nor (b)
Both (a) and (b)
The runway length after correcting for elevation and temperature is 2845 m. If the effective gradient on runway is 0.5 percent then the revised runway length will be
2845 m
2910 m
3030 m
3130 m
As per ICAO recommendation, minimum width of safety area for instrumental runway should be
78 m
150 m
300 m
450 m
If lift off distance of an craft is 2000 m, the clear way at the end of the runway should not be less than
145 m
152.5 m
162.5 m
172.5 m
Assertion A: The width of a taxiway is smaller than the runway width. Reason R: The speed of the aircraft on a taxiway is greater than that on runway. Select your answer based on coding system given below
Both A and R is true and R is the correct explanation of A
Both A and R is true but R is not the correct explanation of A
A is true but R is false
A is false but R is true
The engine failure case for determining the basic runway length may require
Only clearway
Only stop way
Either a clearway or a stop-way
Either a clearway or a stop-way or both
The centre to centre spacing of heliport lighting along the periphery of landing and takeoff area should be
2.5 m
5.0 m
7.5 m
10.0 m
Consider the following statements: Wind rose diagram is used for the purposes of
1. Runway orientation
2. Estimating the runway capacity
3. Geometric design of holding apron of these statements
1 and 2 are correct
2 and 3 are correct
1 and 3 are correct
1 alone is correct
The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60°, the distance of centre of rotation from the nearer main gear, is
12.30 m
11.30 m
10.30 m
9.30 m
As per ICAO, for A, B, and C type of airports, maximum effective, transverse and longitudinal grades in percentage respectively are
1.0, 1.5 and 1.5
1.0, 1.5 and 2.0
1.5, 1.5 and 2.0
2.0, 2.0 and 2.0
The size of landing area for multi engine helicopters operating under 1 FR conditions is
22.5 m × 22.5 m
30 m × 30 m
22.5 m × 30 m
60 m × 120 m
Pick up the correct statement from the following:
Air screw converts the energy given by the engine into speed
The propellers which are driven by turbine engines, are technically called turboprops
The aircrafts which obtain the thrust directly from turbine engine, are called turbo-jets
All the above
According to ICAO, all markings on the runways are
Yellow
White
Black
Red
An airport has 4 gates. If the weighted average gate occupancy time is 30 minutes and gate utilisation factor is 0.5, then the capacity of the gate will be
1 aircraft per hour
2 aircrafts per hour
4 aircrafts per hour
16 aircrafts per hour
The runway orientation is made so that landing and takeoff are
Against the wind direction
Along the wind direction
Perpendicular to wind direction
None of these
The strength of winds is measured with the help of
Beaufort scale
Wind indicator
Barometers
None of these
Consider the following statements regarding ICAO recommendation for correction to basic runway length
1. The basic runway length should be increased at the rate of 7 percent per 300 m rise in elevation above the mean sea level.
2. The basic runway length after having been corrected for elevation should be further increased at the rate of 1 percent for every 1°C rise in airport reference temperature above the standard atmospheric temperature at that elevation.
3. The runway length after having been corrected for elevation and temperature should be further increased at the rate of 20% for every 1 percent of effective gradient. Of these statements
1 and 2 are correct
2 and 3 are correct
1 and 3 are correct
1, 2 and 3 are correct
In approach areas of runways equipped with instrumental landing facilities any object within 4.5 km distance from runway end shall be considered as an obstruction if its height is more than
20 m
30 m
45 m
51 m
Pick up the correct statement from the following:
F.I.R. stands for flight information regions
Radius of control area is 160 km
Radius of control zone is 40 km
All the above
The depressions and undulations in the pavement, are caused due to
Improper compaction of sub-grade
Impact of heavy wheel loads
Punching effect
All the above
Beaufort scale is used to determine
Strength of winds
Direction of winds
Height of air-crafts
None of these
According to the International Civil Aviation Organisation (I.C.A.O.), the runway lengths of aerodromes, have been coded by
Seven English alphabets
Last Seven English alphabets
First Seven English alphabets
First seven natural numbers
The minimum width of clearway is
50 m
100 m
150 m
250 m
Pick up the correct statement from the following:
The distance between the points of intersection of the extreme tangents to the transition curve is kept greater than 7500 m × sum of grade changes at the point of intersection
The rate of change of grade is limited to 0.3% per 30 m length of the curve
According to I.C.A.O. the maximum longitudinal gradient along a runway is limited to 1.5%
All the above
The length of a runway under standard atmospheric conditions is 1800 m. If the actual reduced level of the site is 1200 m, the design length of the runway is
2360 m
2460 m
2560 m
2660 m
Pick up the correct statement from the following:
The speed of the aircraft relative to the ground, is called cruising speed
The speed of the aircraft relative to wind, is called air speed
When wind is blowing the direction of the flight, air speed is less than cruising speed
All the above
According to the International Civil Aviation Organisation (I.C.A.O.) the strength of runway pavements, have been coded by
Seven English alphabets
Last Seven English alphabets
First Seven English alphabets
First seven numbers