For the taxiways, the following statement is true
The maximum longitudinal grade is 3%
The permissible rate of change of grade is 1%
The permissible transverse grade is 1.5%
All the above
Correct Answer :
D. All the above
Related Questions
If the width of the approach area near the runway end is 150 m, the width of the approach area at a distance of 3 kilometres from runway end will be
1500 m
1200 m
1000 m
800 m
The length of clear zone for none instrument runway of a small aircraft is
150 m
300 m
600 m
750 m
Speed of
Sound at 0°C is 1190 kmph
Sound varies 2.4 kmph per degree centigrade rise in temperature
Sound at 0°C is called one Mach
All the above
In an airport, if 4 groups of 5 gates each located well separated are considered for traffic and the future to present traffic ratio is 3, then the total requirement of future gates will be
32
36
44
68
Pick up the correct statement from the following:
Approach zone survey is carried out to determine the elevations of the protruding obstructions above horizontal, conical and transitional surfaces
The wind data of an air port is depicted in the form of a chart known as wind rose
The landing and takeoff of the air craft is made against the wind direction
All the above
Pick up the correct statement from the following:
F.I.R. stands for flight information regions
Radius of control area is 160 km
Radius of control zone is 40 km
All the above
In Intrumental landing system, the middle markers are located
Along the extended centre line of runway end
About 1 km. ahead of the runway threshold
At the runway threshold
About 7 km. ahead of the runway threshold
Pick up the correct statement from the following:
The speed of the aircraft relative to the ground, is called cruising speed
The speed of the aircraft relative to wind, is called air speed
When wind is blowing the direction of the flight, air speed is less than cruising speed
All the above
The fuse large includes
Passengers chamber
Pilot's cabin
Tail of aircraft
All the above
The reduced level of the proposed site of an air port is 2500 m above M.S.L. If the recommended length by I.C.A.O. for the runway at sea level is 2500 m, the required length of the runway is
2500 m
3725 m
3000 m
3250 m
The length of runway is increased per 300 m rise above M.S.L.
3 %
4 %
5 %
7 %
The air is blowing at a speed of 75 knots in the direction of the aircraft flying at a ground speed of 775 knots. The air speed of the aircraft, is
775 knots
75 knots
850 knots
675 knots
The thickness design of the pavement, is decided on the load carried by
Main gears
Nose wheel
Tail wheel
All the above
To cope up high temperature of 196°C, the taxi ways and aprons are constructed with
Asphaltic concrete
Rubberised tar concrete
Plain concrete
All the above
An aircraft is flying in an atmosphere of 30°C with a speed of 1260 km ph. Its speed is known as
Subsonic
Sonic
Super-sonic
Mach
As per ICAO, for A, B, and C type of airports, maximum effective, transverse and longitudinal grades in percentage respectively are
1.0, 1.5 and 1.5
1.0, 1.5 and 2.0
1.5, 1.5 and 2.0
2.0, 2.0 and 2.0
Pick up the correct statement from the following:
Approximate geometric centre of the landing area, is called air port reference point
The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
The location of the air port on a map is the position of air port reference point
All the above
Which of the following is used for servicing and repairs of the aircraft?
Apron
Hanger
Terminal building
Holding apron
The main disadvantage of angle nose out parking configuration of aircraft is that the
Aircraft rear loading door is far away from terminal building.
Hot blast is directed towards the terminal building
Overall apron area required is more
All the above
The engine failure case for determining the basic runway length may require
Only clearway
Only stop way
Either a clearway or a stop-way
Either a clearway or a stop-way or both
The length of a runway under standard atmospheric conditions is 1800 m. If the actual reduced level of the site is 1200 m, the design length of the runway is
2360 m
2460 m
2560 m
2660 m
According to I.C.A.O. the slope of transitional surface at right angles to the centre line of runway, is kept
1 in 4
1 in 5
1 in 6
1 in 7
The best direction of a runway is along the direction of
Longest line on wind rose diagram
Shortest line on the wind rose diagram
Line clear of wind rose diagram
None of these
Assertion A: The width of a taxiway is smaller than the runway width. Reason R: The speed of the aircraft on a taxiway is greater than that on runway. Select your answer based on coding system given below
Both A and R is true and R is the correct explanation of A
Both A and R is true but R is not the correct explanation of A
A is true but R is false
A is false but R is true
For the proposed runway stated in if the aerodrome reference temperature is 17°.2, the net designed length of the runway is
2716 m
2816 m
2916 m
3016 m
Assertion A : The ratio of arriving and departing aircrafts influences the airport Capacity: Reason R : Landing operation is generally given priority over the taking off operation. Select your answer based on the coding system given below:
Both A and R is true and R is the correct explanation of A
Both A and R is true and R is not the correct explanation of A
A is true but R is false
A is false but R is true
For supersonic transport aircraft, the minimum turning radius of taxiway is
60 m
120 m
180 m
240 m
As per UK design criteria, if LCN of aircraft is between 1.25 to 1.5 times the LCN of pavement, then the number of movements allowed are
Zero
300
3000
Unrestricted
The total length of a runway is 1000 m. The elevation at distance 0,200 m, 400 m, 600 m, 800 m and 1000 m are 100.0 m, 99.2 m, 101.0 m, 101.8 m, 101.4 m and 101.0 m respectively. The effective gradient of runway will be.
0.10 %
0.26 %
0.43 %
0.65 %
Consider the following statements: Wind rose diagram is used for the purposes of
1. Runway orientation
2. Estimating the runway capacity
3. Geometric design of holding apron of these statements
1 and 2 are correct
2 and 3 are correct
1 and 3 are correct
1 alone is correct