Hydrogen
Nitrogen
Oxygen
All of these
D. All of these
1.50% to 5.6%
0.05% to 1.75%
0.25 %
None to these
Plastics are chemical resistant
Plastics are durable
Plastics are ductile
Plastics are excellent electric insulators
Lime
Oxide of iron
Hydrated aluminium silicate
Magnesium
Gypsum
Calcium chloride
Calcium carbonate
None of the above
30 minutes
1 hour
6 hours
10 hours
Cutting soft stones
Cutting hard stones
Cutting large blocks of stones
Dressing stones
Texture
Fracture
Cleavage
Structure
Only (i)
Only (ii)
Both (i) and (ii)
Both (ii) and (iii)
The plywoods do not split or crack due to changes in atmosphere
The commercial plywoods are available upto 150 cm wide and upto 300 cm long
The plywoods possess uniform tensile strength in all directions
All the above
Cast steel
Bessemer steel
Mild steel
Whitworth compressed steel
Laterite
Marble
Limestone
All the above
A process of removing sap
Creosoting
Painting with sodium silicate
Coating with tar
Chir
Shishum
Sal
Teak
The theory of formation of concrete is based on the phenomena of formation of voids
The bulking of sand is taken into account while volumetric proportioning of the aggregates
The dry sand and the sand completely flooded with water, have practically the same volume
All the above
It cannot be polished
It is not a fire proof material
It is costly
It has less crushing strength
Fat lime
Quick lime
Hydraulic lime
Poor lime
Clay, lime stone is used as flux
Lime stone, clay is used as flux
Quartz, lime stone and argillaceous iron ores are used as flux
All the above
Larger proportion of lime grounded finer than normal cement
Lesser proportion of lime grounded coarser than normal cement
Lesser proportion of lime grounded finer than normal cement
Excess percentage of gypsum
Innermost annular rings around the pith
Portion of timber between heartwood and cambium layer
Thin layers below the bark
Thin fibre which extends from the pith outwards and holds the annular rings together
Di-calcium silicate
Tri-calcium silicate
Tri-calcium aluminate
All of the above
Titanium steel
Carbon steel
Invar
Stainless steel
Sapwood
Cambium layer
Heart wood
None to these
The plastic bottles are made by the process of blowing
The application of thermo-setting resins on sheets of paper, is called laminating process
The plastic articles made by placing raw material in the desired moulds, is known as moulding process
All the above
Sedimentary rock
Metamorphic rock
Extrusive igneous rock
Intrusive igneous rock
5 %
10 %
15 %
25 %
Surface moisture
Air voids
Viscosity
Clay contents
(i) and (iv)
(ii) and (iii)
(i) and (ii)
(iii) and (iv)
Softening brick earth
Moulding brick earth
Tempering brick earth
Providing brick earth
Radial shakes
Star shakes
Heart shakes
Cup shakes
Roasting is not necessary if iron ore is an oxide
Impurities float on the molten iron as slag
The slag contains lime about 45%
All the above