Home

The lift off distance is the distance along the centre of the runway between the starting point and

A. End of the runway

B. End of stop-way

C. Point where air craft becomes air borne

D. Point where air craft attains a height of 10.7 m

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The reduced level of the proposed site of an air port is 2500 m above M.S.L. If the recommended length…
  2. The threshold markings are
  3. The width and interval of transverse centre line bars along the extended centre line of runway, in approach…
  4. Wing loading of an aircraft is
  5. The depressions and undulations in the pavement, are caused due to
  6. Speed of
  7. Pick up the correct statement from the following:
  8. As per ICAO, for A, B, and C type of airports, maximum effective, transverse and longitudinal grades…
  9. For Class A Air port the difference of reduced levels of higher and lower edges of the conical surface,…
  10. The runway length after correcting for elevation and temperature is 2845 m. If the effective gradient…
  11. Beaufort scale is used to determine
  12. Pick up the correct statement from the following:
  13. Effective length of a runway is the distance between
  14. For the taxiways, the following statement is true
  15. The minimum width of clearway is
  16. The length of runway is increased per 300 m rise above M.S.L.
  17. According to I.C.A.O. all markings on the runways are painted white and on taxiways
  18. The air is blowing at a speed of 75 knots in the direction of the aircraft flying at a ground speed…
  19. As per ICAO recommendation, the rate of change of longitudinal gradient per 30 m length of vertical…
  20. The slope of the obstruction clearance line from the boundary of the heliport should be
  21. Pick up the correct statement from the following:
  22. Which of the following factors are taken into account for estimating the runway length required for…
  23. Consider the following statements: Wind rose diagram is used for the purposes of1. Runway orientation2.…
  24. Pick up the correct statement from the following:
  25. The maximum value of the angle of turning of the nose gear large jet aircrafts, is limited to
  26. Which of the following is an example of failure in flexible pavements?
  27. For the proposed air port, the survey project provides
  28. Assertion A : The ratio of arriving and departing aircrafts influences the airport Capacity: Reason…
  29. In approach areas of runways equipped with instrumental landing facilities any object within 4.5 km…
  30. For determining the basic runway length, the landing case requires that aircraft should come to a stop…