Home

Hot extrusion of aluminium is done in the temperature range of __________ °C.

A. 550-600

B. 450-500

C. 350-400

D. 250-300

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Which of the following emissions in the exhaust gas of an I.C. engine causes the formation of photochemical…
  2. What is the percentage of chromium in 18-4-1 high speed steel?
  3. The material used for coating the welding electrode is termed as the
  4. For grinding of softer materials, the grinding wheel should have __________ grain size.
  5. Air-petrol ratio for maximum power generation in spark ignition engine is about
  6. Change in volume of metals from absolute zero temperature to their melting points is
  7. With increase in temperature, the surface tension of water
  8. Desalination of water
  9. The noble metals
  10. The most abundant metal present in the earth's crust is;
  11. Even though heat transfer co-efficient in boiling liquids is large, use of fins is advantageous, when…
  12. The product (s) of roasting of a sulphide ore is (are)
  13. The same volume of all gases is representative of their
  14. Pick out the correct statement about the condensation.
  15. Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at…
  16. Addition of __________ to steel does not impart hardness.
  17. Heating of ferromagnetic materials to a temperature above Curie temperature makes it
  18. While the thermosetting polymers are amorphous in nature, the thermoplastic polymers are either amorphous…
  19. Consider the equilibrium A(g) + B(g) = AB(g). When the partial pressure of A is 10-2 atm, the partial…
  20. The difference between gross & net calorific values of fuel is due to the
  21. Triple point of water is
  22. Pick out the wrong statement.
  23. Wrought iron is never shaped by
  24. The only suitable method for hardening the low carbon steel is case hardening. Which of the following…
  25. Moist air is cooled along the line of constant __________ , when it is passed over a cold & dry cooling…
  26. Brazing is the joining of metals
  27. Solidification time of a molten metal in a casting is proportional to (where, V = volume of metal &…
  28. Parallel straight line pattern of temperature distribution for both hot and cold fluids is observed…
  29. Theoretical volume of oxygen required for complete combustion of 1Nm3 of acetylene, in oxyacetylene…
  30. Out of the following, the alloy which has equal percentage of constituents, is