Related Questions
What is the correct answer?
4
You are asked to construct a massive dam, the type of cement you will use, is
A. Ordinary Portland cement
B. Rapid hardening cement
D. Blast furnace slag cement
What is the correct answer?
4
Poisson's ratio for concrete
B. Increases with richer mixes
C. Decreases with richer mixes
What is the correct answer?
4
In case of hand mixing of concrete, the extra cement to be added is
What is the correct answer?
4
If fineness modulus of sand is 2.5, it is graded as
What is the correct answer?
4
In a spherical dome subjected to concentrated load at crown or uniformly distributed load, the meridional force is always
D. Tensile or compressive
What is the correct answer?
4
Too wet concrete may cause
What is the correct answer?
4
The compressive strength of 100 mm cube as compared to 150 mm cube is always
What is the correct answer?
4
The slab is designed as one way if the ratio of long span to short span is
What is the correct answer?
4
The load carrying capacity of a helically reinforced column as compared to that of a tied column is about
What is the correct answer?
4
Strength of concrete with passage of time
What is the correct answer?
4
Half of the main steel in a simply supported slab is bent up near the support at a distance of x from the center of slab bearing where x is equal to (Where l is the span)
What is the correct answer?
4
Pick up the correct statement from the following:
A. Segregation is necessary for a workable concrete
B. Consistency does not affect the workability of concrete
C. If the concrete mix is dry, the slump is maximum
What is the correct answer?
4
Workability improved by adding
What is the correct answer?
4
For quality control of Portland cement, the test essentially done is
What is the correct answer?
4
The relation between modulus of rupture fcr, splitting strength fcs and direct tensile strength fcl is given by
What is the correct answer?
4
Maximum percentage reinforcement in case of slabs is limited to
What is the correct answer?
4
If P, Y and Z are the weights of cement, fine aggregates and coarse aggregates respectively and W/C is the water cement ratio, the minimum quantity of water to be added to first batch, is obtained by the equation
A. 0.1P + 0.3Y + 0.1Z = W/C × P
B. 0.3P + 0.1Y + 0.01Z = W/C × P
C. 0.4P + 0.2Y + 0.01Z = W/C × P
D. 0.5P + 0.3Y + 0.01Z = W/C × P
What is the correct answer?
4
The internal dimensions of a ware house are 15 m × 5.6 m, and the maximum height of piles is 2.70 m, the maximum number of bags to be stored in two piles, are
What is the correct answer?
4
If 20 kg of coarse aggregate is sieved through 80 mm, 40 mm, 20 mm, 10 mm, 4.75 mm, 2.36 mm, 1.18 mm, 600 micron, 300 micron and 150 micron standard sieves and the weights retained are 0 kg, 2 kg, 8 kg, 6 kg, 4 kg respectively, the fineness modulus of the aggregate, is
What is the correct answer?
4
Pick up the incorrect statement from the following:
A. A rich mix of concrete possesses higher strength than that a lean mix of desired workability with excessive quantity of water
B. The strength of concrete decreases as the water cement ratio increases
C. Good compaction by mechanical vibrations, increases the strength of concrete
What is the correct answer?
4
The ratio of the length to breadth of a wooden float, is
What is the correct answer?
4
To ensure constant moisture content in aggregates
A. Area of each aggregate pile should be large
B. Height of each aggregate pile should not exceed 1.50 m
C. Aggregate pile should be left for 24 hours before aggregates are used
What is the correct answer?
4
For a longitudinal reinforcing bar in a column, the minimum cover shall neither be less than the diameter of bar nor less than
What is the correct answer?
4
1% of voids in a concrete mix would reduce its strength by about
What is the correct answer?
4
If the engineer-in-charge approves, the 10 cm cubes may be used for the work test of concrete provided maximum nominal size of aggregate, does not exceed
What is the correct answer?
4
Pick up the correct statement from the following:
A. Water enables chemical reaction to take place with cement
B. Water lubricates the mixture of gravel, sand and cement
C. Strength of concrete structure largely depends upon its workability
What is the correct answer?
4
Which of the following statements is incorrect?
A. Higher Vee-Bee time shows lower workability
B. Higher slump shows higher workability
C. Higher compacting factor shows higher workability
What is the correct answer?
4
Maximum distance between expansion joints in structures as per IS: 456 1978 is
What is the correct answer?
4
If the storey height is equal to length of RCC wall, the percentage increase in strength is
What is the correct answer?
4
Construction joints are provided
A. Where B.M. and S.F. are small
B. Where the member is supported by other member
C. At 18 m apart in huge structures