Home

Viscoelastic behaviour is observed in __________ materials.

A. Non-crystalline organic polymeric

B. Ceramic

C. All crystalline

D. All amorphous

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. In an eutectic system, two elements are completely
  2. For dynamic strain measurement, the Wheatstone bridge used is of __________ type.
  3. A dense structure of grinding wheel is not used for the
  4. Pipelines carrying various utilities in chemical industries are identified by their colour codes. The…
  5. Brinell Hardness Number (BHN) for talc is approximately in the range of
  6. The value of for air & most common gases can be safely assumed to be
  7. In chemical dehumidification process
  8. Diffusion co-efficient of a metal in a solid solution depends upon its
  9. Friction factor for fluid flow in pipe does not depend upon the
  10. Electrostatic separation of minerals from each other is based on their differences in the following…
  11. At 100% relative humidity, the dew point temperature of moist air is
  12. Sand used to stop the green sand from sticking to the pattern is termed as the __________ sand.
  13. The best lubricants for a machine working at high temperature & load is
  14. In case of a, centrifugal pump, the ratio h1/h2 is termed as the __________ efficiency (where, h1 =…
  15. __________ property of steel increases by addition of large amount of silicon in it.
  16. Lead is added to 60:40 brass primarily to improve
  17. The most important function of a washer is to provide bearing area and washers are normally specified…
  18. Internal energy of a gas obeying Van-Der- Waals equation of state, [p + (a/v2)] (V - b) = RT, depends…
  19. Joule-Thomson co-efficient is the ratio of
  20. The phenomenon occurring during explosion of a hydrogen bomb is
  21. With decrease in the grain size of a material, its creep resistance
  22. A gas which is collected over water becomes moistened due to water vapor, exerts its own partial pressure…
  23. Which one of the following is incombustible?
  24. A jig is used while __________ a hole.
  25. Nusselt number is related to Grashoff number (Gr) in turbulent & laminar flow respectively, in respect…
  26. In the formation of cermets, the ratio of ceramic material to metallic material is usually 80:20. Which…
  27. The softness or hardness of a grinding wheel depends upon the type & amount of bonding material used.…
  28. Superheating of steam is done at constant
  29. A steam pipe is intended to be insulated with two layers of insulating materials of different thermal…
  30. Heat release during phase change is observed in case of a/an