Gantt charts are used for streamlining the

A. Inventory control

B. Production schedule

C. Sales forecasting

D. Quality control

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. For separating small pieces of metal from engine oil of a car, the best separating technique is the
  2. __________ is not used as the control rod material in a nuclear reactor.
  3. Shaft/rotor speed is most accurately measured by a
  4. Austempering of steel requires it to be heated to 875°C followed by sudden cooling to 250-525°C,…
  5. There are one octahedral void and __________ tetrahedral void in the closest packing of atoms.
  6. Nickel and __________ are the alloying element added in steel to increase its toughness.
  7. Magnetic permeability of iron is increased by its
  8. Normalising does not __________ of a metal.
  9. The laminar boundary layer thickness in zero pressure gradient flow over a flat plate along the x-direction…
  10. Pick out the wrong statement
  11. Cementite is in the lamellar form in the __________ phase of steel.
  12. The lightest non-inflammable gas is
  13. Which of the following is the most wear resistant grade of carbide used for the cutting tools?
  14. Which of the following hardness tests does not measure the indentation hardness of metals and alloys?
  15. Wrought iron does not have
  16. Work hardenable alloy steel used to make the bucket wheel excavators, blades of bulldozers and other…
  17. Joining of thin foils is preferred to be done by
  18. The following thermocouple may be used for measuring temperature upto 1873°K.
  19. Pick out the correct statement.
  20. Particle nature of cathode rays is proved due to the fact that they
  21. Frother is added in the froth floatation cell used in ore beneficiation to stabilise the air bubbles…
  22. Removal of non-condensable from steam or other vapour is termed as the __________ process.
  23. Viscoelastic behaviour is observed in __________ materials.
  24. An abrupt and sudden fall in the reading of barometer is an indication of the
  25. Pick out the wrong statement about the machinability of metals. Machinability of a metal
  26. In a counter flow heat exchanger, hot fluid enters at 170°C & leaves at 150°C, while the cold…
  27. Pick out the wrong statement.
  28. Pipelines carrying various utilities in chemical industries are identified by their colour codes. The…
  29. A fluid is termed as the Newtonian fluid, when the shear stress is __________ the velocity gradient.
  30. With increase in temperature, the electrical conductivity of a __________ decreases.