'Amortization' in respect of financial obligation of a company means the
Liquidation of financial obligations on instalment basis
Commitment of financial obligation on priority
Liquidation of all the obsolete equipments of the company
Modernisation of the plant equipments
Correct Answer :
A. Liquidation of financial obligations on instalment basis
Related Questions
Which of the following equipments is used for liquid dispersion?
Packed column
Venturi scrubber
Bubble cap plate column
Wetted wall column
In the Bayer's process, bauxite is digested under pressure using
H2SO4
NaOH
NH3
HCl
Silicon in steel
Makes it usable in almost all magnetic circuits where alternating current is used
Increases its electrical resistivity and decreases the hysteresis loss
Is present upto 5% & 4% respectively when used in transformers & motor armatures
All 'a', 'b' & 'c'
__________ stress cannot be sustained by a fluid in equilibrium.
Shear
Tensile
Compressive
None of these
Reduction in the grain size reduces the __________ of the material.
Fatigue resistance
Tensile strength
Creep resistance
All (A), (B) & (C)
Capacity & power requirement for an air compressor working at high altitude compared to sealevel will be
More
Less
Same
Either more or less; depends on the climatic conditions
The starting of a car takes time in winter, because the
Octane number of fuel is decreased
Fuel supply for ignition is not sufficient
Vaporisation of the fuel is decreased
Pour point of fuel decreases
The main constituent of bones is
CaF2
Ca3(PO4)2
CaCO3
CaCl2
Diffusion co-efficient of a metal in a solid solution depends upon its
Composition
Temperature
Both (A) & (B)
Neither (A) nor (B)
In fluid flow, and heat and mass transfer, one encounters (i) kinematic velocity (μ), (ii) molecular diffusivity (θ) and thermal diffusivity (α). The units of these quantities are.
μ , α and θ all have units of m/s
μ , α and θ all have units of m2/s
α and θ have units of m2/s, while μ has unit of m/s
α and θ have units of m/s, while μ has unit of m2/s
Moist climate is the most favourable factor in the site selection far a
Steel plant
Textile factory
Petroleum refinery
Coke oven battery
Which of the following pairs is not correctly matched?
Uranium - 233 : Fertile material
Binding energy : Mass defect
Scattering: Absorption cross-section
Number of nucleons : Mass number
For the Stoke's law to be valid in the case of a falling sphere in a fluid, the
Reynolds number (based on sphere diameter) should be < 1
Flow around the sphere should be in turbulent region
Sphere must be metallic
Fluid density should be constant
Cassiterite is an ore of
Tin
Lead
Molybdenum
Chromium
Out of the following, the lowest packing of atoms exists in __________ crystal lattice structure.
Hexagonal close, packed (hcp)
Face centred cubic (fcc)
Body centred cubic (bcc)
Simple cubic
Identify the false statement
Martensitic steels are less susceptible to pitting corrosion than austenitic steels
Pitting corrosion is usually very localised
Hydrogen embrittlement is facilitated by tensile stress
Stress corrosion cracking is facilitated by tensile stress
A material being tested for endurance strength is subjected to the __________ load.
Impact
Completely reversed
Dynamic
Static & dynamic
Alcohols are not suitable as diesel engine fuel because the cetane number of alcohols is
Very low which prevents their ignition by compression
Very high which prevents their ignition by compression
Zero
None of these
Stainless steel is welded using
Oxy-acetylene flame
Oxy-hydrogen flame
Arc welding
Inert gas arc welding
Rain drops falling through atmospheric air attain limited terminal velocity, because of
Upward thrust due to air
Viscous force exerted by air
Surface tension effects of water
Force of gravity
Fibrous fracture is normally encountered in the __________ materials.
Hard
Elastic
Ductile
Brittle
Which of the following has the highest value of refractive index?
Brine (sea water)
Diamond
Distilled water
Glass
The life of a ball bearing is inversely proportional to
(Load)1
(Load)2
(Load)3
(Load)0.33
Sacrificial anode method is used in the protection of pipelines which are buried underground. Sacrificial anode
Occurs higher in the electro-chemical series of metals
Is exemplified by magnesium plate
Is much cheaper than the cathodic base material to be guarded against corrosion
All (A), (B) & (C)
Powder metallurgy is used to produce
High precision components with complex cavities and sharp features
Components of large size
Porosity free components
Components of such alloys whose constituents do not form alloys readily
Minimum safe distance between two liquid fuel storage tanks is equal to (where, H = height of the tank)
H
H/2
H/4
H/6
Fine grained steels have
High brittleness
Higher tendency to distort
High ductility
None of these
Internal energy of a gas obeying Van-Der- Waals equation of state, [p + (a/v2)] (V - b) = RT, depends upon its
Pressure & temperature
Pressure & specific volume
Temperature & specific volume
Temperature only
__________ temperature remains constant during adiabatic saturation process of unsaturated air.
Dew point
Dry bulb
Wet bulb
None of these
Which of the following is the most suitable abrasive for grinding high tensile strength materials?
Silicon carbide
Corundum
Aluminium oxide
Boron carbide