Related Questions
What is the correct answer?
4
Carbon is present in the form of __________ in grey cast iron.
B. Nodular aggregates of graphite
What is the correct answer?
4
The refractory brick which has good thermal shock resistance at high temperature but cracks on cooling below 400°C is
What is the correct answer?
4
The approximate height of a blast furnace having a useful volume of 2000 m3 is about __________ metres
What is the correct answer?
4
Oxyacetylene reducing flame is used while carrying out welding on
What is the correct answer?
4
What is the pH of distilled water?
What is the correct answer?
4
A material being tested for endurance strength is subjected to the __________ load.
What is the correct answer?
4
Ceramic compounds as compared to metallic compounds
B. Resist greater tensile stress at room temperature
C. Have higher melting temperature
D. Are better conductor of electricity at higher temperature
What is the correct answer?
4
For dynamic strain measurement, the Wheatstone bridge used is of __________ type.
A. Voltage sensitive null
B. Voltage sensitive deflected
C. Current sensitive deflected
What is the correct answer?
4
Ammonia leakage in the refrigeration system is detected by
A. Sulphur stick, which on detection gives white smoke
B. Using chemical reagents
What is the correct answer?
4
Consumable electrodes are used in the __________ welding.
What is the correct answer?
4
Lead pencil contains
What is the correct answer?
4
The temperature at which the magnetic property of iron disappears (i.e., it becomes non-magnetic) and its electrical conductivity & specific heat also changes, is called the 'Curie point', which is __________ °C.
What is the correct answer?
4
A cylindrical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the tensile strain, then the Poisson's ratio of the rod is
What is the correct answer?
4
Out of the following, the __________ pipe has the least corrosion resistance.
What is the correct answer?
4
Liquor poisoning generally occurs due to the presence of __________ in it.
What is the correct answer?
4
The most important requirement for aluminium industry is the availability of cheap
What is the correct answer?
4
Resistance of an electrical conductor is proportional to its (where, l = length and A = cross-sectional area of the conductor)
What is the correct answer?
4
The main reducing agent in iron blast furnace is
What is the correct answer?
4
The joint for soldering is supported by binding wire made of
What is the correct answer?
4
Fibrous fracture is normally encountered in the __________ materials.
What is the correct answer?
4
Notched bar test is used for testing the __________ of a material.
What is the correct answer?
4
Force between the molecules of the same substance is called __________ force.
What is the correct answer?
4
Transition from laminar flow to turbulent flow in fluid flow through a pipe does not depend upon the
What is the correct answer?
4
Pick out the correct statement about the condensation.
A. Filmwise condensation gives a lower heat transfer rate than the dropwise condensation
B. Suitable coating or vapour additive is used to promote film wise condensation
C. If a condensing liquid does not wet the surface dropwise, even then condensation will take place on it
D. Reynolds number of condensing liquid is based on its mass flow rate
What is the correct answer?
4
Heating of ferromagnetic materials to a temperature above Curie temperature makes it
A. Insulator for heat & electricity transmission
C. Behave like paramagnetic materials
What is the correct answer?
4
Pick out the wrong statement.
A. The X-rays cannot be deflected by electric field unlike cathode rays
B. The intensity of X-rays can be measured by ionisation current produced due to the ionisation of gas by X-rays
C. The quality of X-rays can be controlled by varying the anode-cathode voltage
D. Crystal structure of a material can be studied by an electron microscope
What is the correct answer?
4
In Imperial Smelting Process for extraction of zinc, zinc vapour thus produced is quenched in the external condenser by the use of the following:
A. Jet of water at high pressure
C. Mixture of water and air
What is the correct answer?
4
Thermit welding is categorised as the __________ welding.
What is the correct answer?
4
Absolute zero pressure can be attained at a temperature of
What is the correct answer?
4
Which of the following materials does not form adherent oxide film on surface?