What is the value of included angle of a triangular notch for maximum discharge?

A. 30°

B. 60°

C. 90°

D. 120°

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Even though heat transfer co-efficient in boiling liquids is large, use of fins is advantageous, when…
  2. Which of the following material handling equipments is not suitable for moving materials in varying…
  3. With increase in annealing temperature, the following defect density decreases.
  4. Normalising does not __________ of a metal.
  5. __________ wire is never used for making the heating element.
  6. Reduction in the grain size reduces the __________ of the material.
  7. Glycerine is used as a coolant in cooling of some engines instead of water, because
  8. Cupola produces __________ iron.
  9. Angular displacement can be measured suitably by a
  10. Pick out the wrong conversion of absolute & kinematic viscosities.
  11. The pressure drop per unit length for laminar flow of fluid through a long pipe is proportional to (where,…
  12. Babbitt lining is used on brass/bronze bearings to increase the
  13. Which of the following is an unconventional source of energy?
  14. Maximum permissible sulphur content in steel is __________ percent.
  15. Nickel and __________ are the alloying element added in steel to increase its toughness.
  16. Which of the following fastening devices has its both ends threaded?
  17. Atomic __________ is a whole number for an element.
  18. Which of the following gases cause global warming?
  19. Out of the following, the best material capable of withstanding shock & vibration without the danger…
  20. As per the Indian boiler regulation (IBR), the type of joint preferred for the circumferential joint…
  21. The main constituent of bones is
  22. Multistage compression of air as compared to single stage compression offers the advantage of
  23. The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer…
  24. Which of the following parameters is not responsible for the heat loss from a hot steam carrying bare…
  25. Thermit welding is categorised as the __________ welding.
  26. Oxyacetylene reducing flame is used while carrying out welding on
  27. Density in the solid state is slightly less than that in its liquid state, in case of
  28. Ceramic compounds as compared to metallic compounds
  29. The trace metal present in insulin is
  30. Consideration of the creep is the most important in case of the