Home

Which 2950 command assigns a VLAN to an interface?

A. vlan-membership static

B. vlan

C. switchport access vlan

D. switchport mode access

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. EIGRP generates hellos every _________ seconds on LAN segments.
  2. If you see a VC with an inactive status, this indicates ____________.
  3. Which of the following is not an advantage of route summarization?
  4. An OSPF's router ID is based on __________.
  5. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  6. Which of the following situations are best for DDR connections?
  7. What command activates the IP routing process?
  8. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  9. The _________ reference point defines the connection between the NT2 and the NT1.
  10. Which router command creates a standard named ACL called test?
  11. VLSM allows you to summarize __________ back to the class boundary.
  12. Enter the wildcard mask value to match on every bit position in an address: _________.
  13. _________ is/are a routed protocol.
  14. You are given a class C network and you have four LAN segments with the following numbers of devices:…
  15. Which command is used to define the local addresses that are statically translated to global addresses?
  16. When examining the IP routing table, an EIGRP route will be shown as what letter?
  17. An _____________ is a public IP address associated with an inside device.
  18. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  19. Which of the following is a private address?
  20. If you wanted a list of parameters for the show command, you would type ________.
  21. Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________…
  22. A _________ provides a high-speed infrastructure to move data between storage devices and file servers.
  23. When choosing a dynamic routing protocol, which of the following should not be considered?
  24. Which of the following is not true concerning TCP?
  25. The ___________ converts an ISDN four-wire connection to a two-wire connection.
  26. Which controller command specifies how ones and zeros are represented on a digital circuit?
  27. Which VTP mode(s) will propagate VTP messages?
  28. How many steps do LCP and NCP go through when setting up a connection?
  29. Which control sequence moves the cursor to the end of the line?
  30. Which metric components, by default, are used in IGRP? (Choose all the correct answers.)