Which of the following is the most expensive type of WAN connection?

Question

Which of the following is the most expensive type of WAN connection?

A. Dedicated circuit connection

B. Circuit-switched connection

C. Packet-switched connection

Share this question with your friends

Show all WAN MCQ

Comment

What router command saves the active configuration to NVRAM?

A. copy nvram startup-config

B. copy startup-config running-config

C. copy running-config nvram

D. copy running-config startup-config

Discuss this answer

What would you use to prevent a packet from traveling around a routing loop forever?

A. Split horizon

B. Poison reverse

C. Hold-down timer

D. TTL

Discuss this answer

A routing protocol that supports route summarization must perform all except which of the following?

A. Carry the subnet mask with the network entry.

B. Make routing decisions based on the entire destination IP address.

C. Summarize entries so that the same lowest-order bits match.

D. None of these.

Discuss this answer

Which types of memory do not maintain their contents during a power-off state?

A. NVRAM

B. ROM

C. RAM

D. Flash

Discuss this answer

Which control sequence moves the cursor to the end of the line?

A. CTRL-A

B. ctrl-p

C. ctrl-e

D. ctrl-z

Discuss this answer

Which interface type is used to connect to the serial interface of a router?

A. EIA/TIA-232

B. V.35

C. DB-60

D. X.21

Discuss this answer

_________ allows you to create this summarization: 10.0.0.0/7.

A. Subnetting

B. CDR

C. Supernetting

D. VLSM

Discuss this answer

Which router-on-a-stick command defines the VLAN for the interface?

A. vlan

B. encapsulation

C. trunk

D. frame-type

Discuss this answer

With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.

A. Store-and-forward

B. Cut-through

C. Fragment-free

D. Runtless

Discuss this answer

When configuring the ip nat inside source command, which parameter must you specify to perform PAT?

A. pat

B. overload

C. load

D. port

Discuss this answer

Which of the following is false concerning VLANs?

A. A VLAN is a broadcast domain.

B. A VLAN is a logical group of users.

C. A VLAN is location-dependent.

D. A VLAN is a subnet.

Discuss this answer

Enter the wildcard mask value to match on every bit position in an address: _________.

A. 255.0.0.0

B. 0.0.0.0

C. 255.255.255.255

D. 255.255.0.0

Discuss this answer

When choosing a networking product, you should consider all of the following except _______.

A. Ease of installation and support

B. Product features and functions

C. Backplane capacity

D. Amount of memory

Discuss this answer

Which is not one of the three main functions of a layer-2 device?

A. Learning

B. Forwarding

C. Listening

D. Removing loops

Discuss this answer

RIP has a hold-down period of ____________ seconds.

A. 60

B. 120

C. 180

D. 280

Discuss this answer

A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain information for a user.

A. SAN

B. LAN

C. CN

D. SAN and CN

Discuss this answer

Cisco routers generate LMI enquiries every _ seconds and a full status update every ___ seconds.

A. 10, 60

B. 10, 6

C. 60, 300

D. 15, 60

Discuss this answer

If you wanted a list of parameters for the show command, you would type ________.

A. LOOK

B. VIEW

C. SHOW

Discuss this answer

Which of the following is the most expensive type of WAN connection?

A. Dedicated circuit connection

B. Circuit-switched connection

C. Packet-switched connection

Discuss this answer

When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt you for? (Choose all correct answers.)

A. TFTP server IP address

B. Verification to copy

C. Source filename

D. Destination filename

Discuss this answer

Which of the following is true concerning 802.1Q?

A. It supports hub connections.

B. It is supported on both the 1900 and 2950 switches.

C. The native VLAN is tagged.

D. The original Ethernet frame is not modified.

Discuss this answer

When connecting a switch to a router, use a ___________ cable.

A. Crossover

B. Straight-through

C. Rollover

Discuss this answer

If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.

A. Green

B. Off

C. Amber

D. None of these

Discuss this answer

Which metric components, by default, are used in IGRP? (Choose all the correct answers.)

A. Delay

B. Reliability

C. Load

D. Bandwidth

Discuss this answer

When you have configured PPP on an interface and use the show interfaces command, what state indicates the successful negotiation of a network layer protocol?

A. ACK

B. CHALLENGE

C. CLOSED

D. OPEN

Discuss this answer

An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.

A. 120

B. 122

C. 130

D. 132

Discuss this answer

Which frame field is different between ISO HDLC and Cisco's HDLC?

A. Address

B. Control

C. Flag

D. Proprietary

Discuss this answer

The _________ reference point defines the connection between the NT2 and the NT1.

A. P

B. Q

C. R

D. T

Discuss this answer

You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?

A. 30

B. 62

C. 126

D. 254

Discuss this answer

BPDU stands for ____________.

A. Bridge Protocol Description Unicast

B. Bridge Protocol Data Unit

C. Bridge Protocol Description Unit

D. Bridge Protocol Data Unicast

Discuss this answer

Accepted Answer

A. Dedicated circuit connection

Which of the following is the most expensive type of WAN connection?

Correct Answer :

Show all WAN MCQ

Related Questions

What router command saves the active configuration to NVRAM?

What would you use to prevent a packet from traveling around a routing loop forever?

A routing protocol that supports route summarization must perform all except which of the following?

Which types of memory do not maintain their contents during a power-off state?

Which control sequence moves the cursor to the end of the line?

Which interface type is used to connect to the serial interface of a router?

_________ allows you to create this summarization: 10.0.0.0/7.

Which router-on-a-stick command defines the VLAN for the interface?

With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.

When configuring the ip nat inside source command, which parameter must you specify to perform PAT?

Which of the following is false concerning VLANs?

Enter the wildcard mask value to match on every bit position in an address: _________.

When choosing a networking product, you should consider all of the following except _______.

Which is not one of the three main functions of a layer-2 device?

RIP has a hold-down period of ____________ seconds.

A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain information for a user.

Cisco routers generate LMI enquiries every _ seconds and a full status update every ___ seconds.

If you wanted a list of parameters for the show command, you would type ________.

Which of the following is the most expensive type of WAN connection?

When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt you for? (Choose all correct answers.)

Which of the following is true concerning 802.1Q?

When connecting a switch to a router, use a ___________ cable.

If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.

Which metric components, by default, are used in IGRP? (Choose all the correct answers.)

When you have configured PPP on an interface and use the show interfaces command, what state indicates the successful negotiation of a network layer protocol?

An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.

Which frame field is different between ISO HDLC and Cisco's HDLC?

The _________ reference point defines the connection between the NT2 and the NT1.

You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?

BPDU stands for ____________.

Also checkout

Which of the following is the most expensive type of WAN connection?

Correct Answer :

Show all WAN MCQ

Related Questions

What router command saves the active configuration to NVRAM?

What would you use to prevent a packet from traveling around a routing loop forever?

A routing protocol that supports route summarization must perform all except which of the following?

Which types of memory do not maintain their contents during a power-off state?

Which control sequence moves the cursor to the end of the line?

Which interface type is used to connect to the serial interface of a router?

_________ allows you to create this summarization: 10.0.0.0/7.

Which router-on-a-stick command defines the VLAN for the interface?

With _________ switching, the switch reads the destination MAC address of the frame andimmediately starts forwarding the frame.

When configuring the ip nat inside source command, which parameter must you specify to perform PAT?

Which of the following is false concerning VLANs?

Enter the wildcard mask value to match on every bit position in an address: _________.

When choosing a networking product, you should consider all of the following except _______.

Which is not one of the three main functions of a layer-2 device?

RIP has a hold-down period of ____________ seconds.

A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain information for a user.

Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________ seconds.

If you wanted a list of parameters for the show command, you would type ________.

Which of the following is the most expensive type of WAN connection?

When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt you for? (Choose all correct answers.)

Which of the following is true concerning 802.1Q?

When connecting a switch to a router, use a ___________ cable.

If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.

Which metric components, by default, are used in IGRP? (Choose all the correct answers.)

When you have configured PPP on an interface and use the show interfaces command, what state indicates the successful negotiation of a network layer protocol?

An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.

Which frame field is different between ISO HDLC and Cisco's HDLC?

The _________ reference point defines the connection between the NT2 and the NT1.

You are given a Class B network with a subnet mask of 255.255.255.192. How many hostaddresses are there on each subnet?

BPDU stands for ____________.

Also checkout

With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.

Cisco routers generate LMI enquiries every _ seconds and a full status update every ___ seconds.

You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?