Home

________ topologies in NBMA environments do not have problems with split horizon.

A. Partially meshed

B. Fully meshed

C. Hub and spoke

D. Star

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Which of the following is not an advantage of DHCP?
  2. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  3. Which router command creates a standard named ACL called test?
  4. Which types of memory do not maintain their contents during a power-off state?
  5. Distance vector protocols use ___________ to disseminate routing information.
  6. Which of the following is true concerning ACLs?
  7. _________ describe(s) users working from home.
  8. OSPF uses __________ as a metric.
  9. The function of the MODE button is to __________.
  10. Which of the following is a valid subnet mask value?
  11. Private addressing is defined in RFC ______.
  12. Which VTP mode(s) will propagate VTP messages?
  13. Which command assigns a default gateway to the 2950 switch?
  14. What would you enter to see the last few commands you entered?
  15. Which of the following is a private address?
  16. A 1924 has _________ Ethernet interfaces.
  17. You are given the following addressing information: 10.0.8.0/22. What type of address is this?
  18. Which router command would you use to view the configuration register value?
  19. When using the show interfaces command, which Frame Relay information can you not see?
  20. Which of the following is true concerning full-duplexing?
  21. How many steps do LCP and NCP go through when setting up a connection?
  22. During the learning function, the switch places addresses and ports in a(n) _________ table.
  23. ___________ has both physical and logical ring topologies.
  24. An OSPF's router ID is based on __________.
  25. Which prompt indicates that you are at User EXEC mode?
  26. _________ defines how the Frame Relay DTE and DCE interact with each other.
  27. Which router-on-a-stick command defines the VLAN for the interface?
  28. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  29. A _________ is a network that provides a secure connection from a company to other business partners.
  30. Which IGRP command allows unequal-cost load balancing?