Related Questions
What is the correct answer?
4
Extended IP ACLs should be placed as close to the ____________ device as possible.
What is the correct answer?
4
When configuring a router-on-a-stick, the configuration is done on __________.
What is the correct answer?
4
Ethernet ___________ has/have both a physical and logical bus topology.
D. 10BaseT, 10Base2, and 10Base5
What is the correct answer?
4
If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
What is the correct answer?
4
When connecting a router to a PC, use a __________ cable.
What is the correct answer?
4
__________ states that if a neighboring router sends a route to a router, the receiving router will not propagate this route back to the advertising router on the same interface.
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
Which 2950 command enables trunking?
What is the correct answer?
4
Which of the following is not true concerning TCP?
A. Provides for reliable connections
B. Uses windowing for flow control
C. Multiplexes applications
D. Is more efficient than UDP
What is the correct answer?
4
An _____________ is a public IP address associated with an inside device.
A. Inside global IP address
B. Inside local IP address
C. Outside global IP address
D. Outside local IP address
What is the correct answer?
4
Which of the following situations are best for DDR connections?
A. Primary WAN connection
B. A lot of constant traffic
What is the correct answer?
4
Which router command would you use to test only layer-3 connectivity?
What is the correct answer?
4
Which of the following is a disadvantage of SANs?
What is the correct answer?
4
When choosing a networking product, you should consider all of the following except _______.
A. Ease of installation and support
B. Product features and functions
What is the correct answer?
4
With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
What is the correct answer?
4
You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
A. 00011011.10100010.00000100
B. 00000000.00000001.00000100
C. 00000001.10100010.00000100
D. 00000001.10100001.00000010
What is the correct answer?
4
__________ allows you to distribute connection requests destined to a single IP address to multiple machines.
What is the correct answer?
4
PPP can do all of the following except ___________.
What is the correct answer?
4
RIP generates routing updates every _________ seconds.
What is the correct answer?
4
Enter the wildcard mask value to match on every bit position in an address: _________.
What is the correct answer?
4
The ___________ is the point where the carrier's responsibility ends and yours begins.
What is the correct answer?
4
IOS images can be loaded from all the following except:
What is the correct answer?
4
You are given a Class C network, 192.168.1.0/24. You need one network with 120 hosts
and two networks with 60 hosts. How many subnet masks do you need?
What is the correct answer?
4
Which router command would you use to view the configuration register value?
What is the correct answer?
4
What command assigns a User EXEC password to a 2950 switch?
What is the correct answer?
4
When choosing a WAN solution, consider all of the following except __________.
What is the correct answer?
4
The switch port that is chosen to forward traffic for a segment is called a __________.
What is the correct answer?
4
Which router command would take you back to a suspended telnet session?
What is the correct answer?
4
Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________ seconds.
What is the correct answer?
4
Which of the following is the most expensive type of WAN connection?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection