Home

When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt you for? (Choose all correct answers.)

A. TFTP server IP address

B. Verification to copy

C. Source filename

D. Destination filename

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt…
  2. Which of the following commands belongs on the physical interface when using dialer profiles?
  3. Which 2950 command assigns a VLAN to an interface?
  4. Which command is used to define the local addresses that are statically translated to global addresses?
  5. You are at User EXEC mode and type the letter e. What message appears?
  6. Which of the following WAN categories does ISDN fall under?
  7. Which router command clears all of the static translations in the address translation table?
  8. OSPF uses __________ as a metric.
  9. Which of the following reasons might you need to use address translation?
  10. You have this binary value: 11000001. This equates to _____ in decimal.
  11. A _________ routes between different autonomous systems.
  12. The _________ is your network equipment, which includes the DCE (e.g., a modem) and the DTE (e.g., a…
  13. Which of the following is not an advantage of DHCP?
  14. IGRP generates an update every ___________ seconds.
  15. The router automatically saves its configuration.
  16. A _________ connects two or more LANs in the same geographic area.
  17. A __________ topology uses a single connection to connect all devices together.
  18. A _________ uses Gigabit Ethernet as a media type
  19. Which command takes you from Privilege EXEC mode to User EXEC mode?
  20. Which router command specifies the ISDN switch the router is connected to?
  21. With a crossover cable, which pins are crossed over?
  22. The address of a Frame Relay VC is called a ___________.
  23. ___________ has both physical and logical ring topologies.
  24. The slot number of a 1900's Fast Ethernet uplink ports is ________.
  25. A _________ provides a high-speed infrastructure to move data between storage devices and file servers.
  26. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  27. A _________ is used to connect networking devices that are in a very close geographic area, such as…
  28. EIGRP uses the _________ algorithm to update its routing table.
  29. Which of the following trunking methods is/are proprietary to Cisco?
  30. When connecting a switch to a router, use a ___________ cable.