Home

A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed drawings.

A. Engineer's

B. Metric

C. Architect's

D. None of the above

Correct Answer : A.


Download Objective type questions of Engineering Drawing PDF

Visit our PDF store

Get all objective type questions of Engineering Drawing MCQ

Also checkout these categories

H.C.F and L.C.M MCQ Decimal Fraction MCQ Physiological and Anatomy of Plants MCQ Phylum - Arthropoda MCQ Pteridophyta MCQ Botany MCQ Fluid Mechanics MCQ Rearrangement Set 12 MCQ Data Structure MCQ Automobile Engineering MCQ Chemical Bonding and Molecular Structure MCQ General knowledge MCQ

Please do not use chat terms. Example: avoid using "grt" instead of "great".

Submit
Load More..
You can do it
  1. This type of surface may be a plane, a single curved surface, or a warped surface:
  2. Students can complete an associate's degree in drafting which normally takes about ________ years to…
  3. This type of axonometric drawing has equal foreshortening along two axis directions and a different…
  4. These units are based on inch-foot and yard measurements:
  5. This material is used in masonry construction, most commonly for ornamental facing:
  6. These are joined together in the field to build a structure:
  7. The foundation contractor will work with the following architectural plans.
  8. In this type of projection, each of the axes has different ratios of foreshortening:
  9. This type of solid has a polygon for a base and triangular lateral faces that intersect at a vertex:
  10. Spur gear design normally begins with selecting this:
  11. An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
  12. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter…
  13. The View toolbar will position the view of the 3-D solid toward the ________.
  14. On a floor plan the dashed line that appears approximately 24 outside the exterior wall represents the…
  15. To avoid having to dimension to a hidden feature the drafter can utilize a ________ section.
  16. Drawings created with commercial software are typically saved as:
  17. Two-point perspective is also known as:
  18. This process recognizes the inherent interrelationships between design and manufacturing:
  19. Once the architect has finalized the house plans with the client any changes to the design requested…
  20. This type of section is limited by a break line:
  21. These are vertical distances above a common datum, reference plane, or point:
  22. The bounding box method for setting up an isometric drawing helps the drafter ________.
  23. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
  24. This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal…
  25. In an exploded assembly drawing it is customary for the drafter to use a ________ line to illustrate…
  26. When designing a home for a client, one of the most important predesign considerations that an architect…
  27. The maximum and minimum sizes of a feature are identified by a ________ tolerance.
  28. In the section view, the areas that would have been in actual contact with the cutting plane are shown…
  29. There should be a visible gap between the wall and the ________ line.
  30. In this type of drawing, vertical pipes may be revolved into the horizontal plane: