Related Questions
What is the correct answer?
4
This is the range of digital or hard copy documents that specify the physical function requirements for a product:
What is the correct answer?
4
If a designer is developing a plan for a project in which the entire part is made out of ¾ thick plywood and he only wants to use one view, he should use the ________ view.
What is the correct answer?
4
Elevation drawings will include information about ________.
What is the correct answer?
4
This type of section is limited by a break line:
What is the correct answer?
4
Isometric drawings are often used by ________ to help illustrate complex designs.
What is the correct answer?
4
These drawings are given to contractors to perform work or manufacture individual parts:
What is the correct answer?
4
Several of the tools used in traditional drafting include the following:
A. Parallel straight edge
What is the correct answer?
4
This is formed where three or more surfaces intersect:
What is the correct answer?
4
Approximately this much of the cost of product development and manufacture is determined at the design stage:
What is the correct answer?
4
These breaks are used to shorten the view of an object:
What is the correct answer?
4
Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:
What is the correct answer?
4
When lettering a CAD drawing, for clarity you should limit the number of fonts to:
What is the correct answer?
4
This is the bottom surface joining the sides of two adjacent threads:
What is the correct answer?
4
Most architectural drawings produced for field use by building contractors are printed on architectural D size paper which measures ________.
What is the correct answer?
4
This type of solid has two bases that are parallel equal polygons:
What is the correct answer?
4
These are lines drawn on a map to locate, in the plan view, points of equal ground elevation:
What is the correct answer?
4
These gears transmit power between shafts whose axes intersect at any angle:
What is the correct answer?
4
This is a conical-shaped recess around a hole, often used to receive a tapered screw head:
What is the correct answer?
4
This type of rapid prototyping system uses a laser to fuse powdered metals, plastics, or ceramics:
A. Fused deposition modeling
B. Stereo lithography apparatus
D. Selective laser sintering
What is the correct answer?
4
The primary unit of measurement for engineering drawings and design in the mechanical industries is the:
What is the correct answer?
4
In perspective drawings this is placed between the observer and the object:
A. Vanishing point / horizon
D. Plane of projection / picture plane
What is the correct answer?
4
One critical issue drafters need to pay close attention to is the ________.
What is the correct answer?
4
Schematic and single-line diagrams should be arranged so that signal or transmission path from input to output proceeds in this fashion:
A. Right to left and top to bottom
B. Right to left and bottom to top
C. Left to right and top to bottom
D. Left to right and bottom to top
What is the correct answer?
4
A secondary auxiliary view is a projection off of the ________.
C. Primary auxiliary view
What is the correct answer?
4
To avoid having to dimension to a hidden feature the drafter can utilize a ________ section.
What is the correct answer?
4
When creating a block the drafter needs to pay particular attention to selecting a base point because it determines the ________.
What is the correct answer?
4
In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:
What is the correct answer?
4
On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
What is the correct answer?
4
This is used to indicate that a surface is to be machined:
What is the correct answer?
4
In a CAD system, you can draw an ellipse by specifying these:
B. The midpoint and end points
C. The center and major and minor axes