If you see a VC with an inactive status, this indicates ____________.
The connection between both Frame Relay DTEs is up and operational.
The connection between your Frame Relay DTE and DCE is up and operational, but there is something wrong with connection between your connected Frame Relay switch and the destination DTE.
You are not receiving any LMI messages from the Frame Relay switch.
Correct Answer :
B. The connection between your Frame Relay DTE and DCE is up and operational, but there is something wrong with connection between your connected Frame Relay switch and the destination DTE.
Related Questions
Which type of traffic is not flooded?
Multicast
Known unicast
Broadcast
Unknown unicast
The function of the MODE button is to __________.
Change the status of the ports
Affect what the SYSTEM and RPS LEDs represent
Affect what the port LEDs represent
Change the status of all the LEDs
IOS images can be loaded from all the following except:
ROM
Flash
NVRAM
TFTP
Which command is used to define the local addresses that are statically translated to global addresses?
ip nat inside source static
ip nat inside
ip nat inside source list
ip nat pool
172.16.240.256 is a class __________ address.
A
B
C
None of the above
Which of the following is false concerning OSPF?
It provides a loop-free topology.
It is a classful protocol and allows for a hierarchical design.
It requires more memory and processing cycles than distance vector protocols.
It is complex to configure and difficult to troubleshoot.
With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.
Store-and-forward
Cut-through
Fragment-free
Runtless
You are given the following addressing information: 172.17.16.255/23. What type of address is this?
Network
Directed Broadcast
Host
You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks with 30 hosts. What are the subnet mask values you could use?
255.255.255.128 and 255.255.255.192
255.255.255.224 and 255.255.255.240
255.255.255.192 and 255.255.255.224
None of these
You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol is down. What does this indicate?
There is a physical layer problem.
There is a data link layer problem.
There is a network layer problem.
There is no problem.
The _______ program goes out and finds the IOS and loads it.
ROMMON
Bootstrap
Mini-IOS
Loader
The _________ command takes you from User EXEC mode to Privilege EXEC mode
DISABLE
ENABLE
If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
Green
Off
Amber
None of these
A ___________ is similar to a telephone circuit-switched connection.
PVC
SVC
Which router command would you use to test only layer-3 connectivity?
telnet
show cdp traffic
show interfaces
traceroute
Which of the following is true concerning ACLs?
Order of the statements is automatic.
All statements are processed.
If no match is found, the packet is permitted.
You can delete a specific statement in a named list.
What router command saves the active configuration to NVRAM?
copy nvram startup-config
copy startup-config running-config
copy running-config nvram
copy running-config startup-config
What command creates a DHCP address pool on a router?
ip dhcp
ip pool dhcp
ip dhcp pool network
ip dhcp pool
A Class A address has _________ host bits.
8
16
20
24
How would you suspend a telnet session?
CTRL-SHIFT-X 6
CTRL-SHIFT-6 X
CTRL-6 X
CTRL-C
A __________ topology uses a single connection to connect all devices together.
Bus
Star
Point-to-point
Ring
RIP supports load balancing for up to __________ ___________ paths.
Six, unequal-cost
Four, unequal-cost
Four, equal-cost
Six, equal-cost
The ___________ converts an ISDN four-wire connection to a two-wire connection.
NT5
NP1
NT1
TN1
What uses 64 Kbps of bandwidth?
PRI
BRI
DS1
DS0
The slot number of a 1900's Fast Ethernet uplink ports is ________.
0
1
2
No slot number is used
When connecting a switch to a router, use a ___________ cable.
Crossover
Straight-through
Rollover
An _____________ is a public IP address associated with an inside device.
Inside global IP address
Inside local IP address
Outside global IP address
Outside local IP address
Which of the following is true concerning bridges?
They switch frames in hardware.
They support half- and full-duplexing.
They support one collision domain for the entire bridge.
They do only store-and-forward switching.
Annex A is which LMI standard?
Cisco
ITU-T Q.933
ANSI
If the port status LED on a 2950 is ________, there is a physical layer connection problem.
Flashing green and amber
Flashing green
Amber
Flashing amber